EXAGATE SYSGuard 7001 User manual

Welcome to SYSGuard 7001 Main Unit Quick Installation Guide
INTRODUCTION
Box Contents
SYSGuard 7001 Main Unit
1Assembly Screws
Mounting Kit
Power Cable
Step 1
Plug-in Power Cable to SYSGuard 7001 Main Unit. Wait for the “READY”LED. When the LED
comes online SYSGuard 7001 Main Unit is ready to run.
Step 2
Main unit is equipped with default IP address
(192.168.1.234). For the first access to the
device a PC must be used to access the main
unit and devices should be connected to the
same network.
Your PC should have a static IP in order to
access SYSGuard 7001. You can carry out
these settings in TCP/IP Settings sections of
Local Area Network Connection options.
Step 3
Write 192.168.1.234 on the address bar of
your browser (for instance Internet Explorer) and
press Enter button.
Homepage of the SYSGuard7001 Main Unit is as
follows: Default user name is “admin” and
password is “123456”.
Before Installation!
Make sure your device is properly
mounted and ready to operate
safely.
Head Office
A: Yeşilce Mh. Doğa Sk. Kökten Plaza No:6 Kat:2 34418 Kağıthane - İstanbul
T: + 90 212 275 73 22 F: [phone]
E: [e-mail]
Support
[e-mail]

Sensor Connecting Diagrams
Step 4
Before connecting the sensor to the system, it is necessary to have SYSGuard 7001 Main Unit gone
into Sensor Assignment Mode. Enter “Sensor Settings” section in WebPack interface. Click on “Add
New Sensor”, SYSGuard 7001 Main Unit will go Sensor Assignment Mode.
Head Office
A: Yeşilce Mh. Doğa Sk. Kökten Plaza No:6 Kat:2 34418 Kağıthane - İstanbul
T: + 90 212 275 73 22 F: [phone]
E: [e-mail]
Support
[e-mail]
Digital Input/Output Connection Dry Contact Connection
Water Detect Cable and Smoke Detector Connection Diagrams
*** Same Diagram For Door Detector
***Same Diagram For PIR (Movement) Detector

Head Office
A: Yeşilce Mh. Doğa Sk. Kökten Plaza No:6 Kat:2 34418 Kağıthane -
İstanbul T: [phone] F: [phone]
E: [e-mail]
Support
[e-mail]