3 Short manual
3.1 Switching On an Off
The de ice can be switched on and of by use of the integrated key switch.
3.2 Status isplay uring startup
When switching on the de ice, the green status LED gi es feedback o er the battery
status of the de ice.
Batterystatus-LED (directly after startup)
3x Flashing Battery is fully charged.
2x Flashing Battery is not fully charged, but ready for use.
1x Flashing
Battery is discharged, and must be charged before the device is
being used again.
Batterystatus-LED durin use
Continuous Flashing
Battery is discharged, and must be charged before the device is
being used again.
3.3 Manual ignition of the Flame effect
To pre ent the effect from being triggered by mistake, two ignition buttons ha e been
integrated into the grips.
When you wish to use the effect, both buttons must be pressed at the same time. If
one of the buttons is pressed, the red status LEDs will start flashing. If the second
button is also pressed, the effect will be acti ated.
4 Important Safety functions
Next tot he two buttons needed fort he manual ignition, othe saftey features ha e
been integrated into the de ice.
Ifo ne of the two buttons is being pressed during startup,the red LEDs will start to
flash rapidly, and the de ice will not start correctly. Only if both buttons are not
pressed, the de ice will start.
During use, the red status-LEDs will flash shortly e ery four seconds. This is meant
to remind the user that the de ice is still acti ated.
