Extron electronics SMB 110 Series User manual

1
SMB 110 Series • Installation Guide
The Extron SMB 110 Series Surface Mount Boxes are
designed for mounting various Extron architectural
products, including standard gang-size plates, AAP
Mounting Frames, and MediaLink®Controllers. The
SMB 110 Series is available in one- to ve-gang sizes.
This guide provides information for an experienced
installer.
The SMB 110 Series enclosure can be mounted to provide access for under-table cabling or rear
cabling. Mounting the enclosure is the same for both access methods.
Locate a Suitable Mounting Location, Mark and Drill Pilot Holes
The mounting hole pattern for the SMB 110 enclosures fit US standard gang-sized devices.
1. Find a suitable location and position the enclosure.
2. Mark pilot hole locations for the desired mounting holes.
3. For under-table cable access, mark the bottom cutout locations.
4. Remove the enclosure.
5. Drill 3/32 inch (2.4 mm) pilot holes for the mounting holes marked in step 2.
Mounting Holes (2)
Alternate
Mounting Hole
Top View - 3 Gang
Gr
ounding
Stud
Mount the SMB Enclosure
1. For through-table cable access, cut the cable access holes marked in step 3above.
2. Fasten the enclosure to the table with the supplied #8 wood screws.
For standard mounting, route the
cables from under the table.
Mounting Screws
#8 Wood (2)
Mou
n
#
8 W
o
For through-table cable access see Through-table Cable Access below. For rear cabling see Rear Cabling on page2
Through-table Cable Access
1. Route cables from under the table as necessary.
For standard mounting, route the
cables from under the table.
Mounting Screws
#8 Wood (2)
Mou
n
#
8 W
o
2. If necessary, the bottom plate of each SMB enclosure includes a #6-32 stud insert and nut for grounding.
NOTE: Ensure that the installation meets the national, local, and
state regulatory requirements, including building, electrical,
and safety codes, and ADA accessibility requirements.

268-2710-01 Rev. B
06 16
Extron Headquarters
+1.800.633.9876 (Inside USA/Canada Only)
Extron Asia
+65.6383.4400
Extron China
+86.21.3760.1568
Extron Australia
+61.8.8351.2188
Extron Europe
+31.33.453.4040
Extron Japan
+81.3.3511.7655
Extron Middle East
+971.4.299.1800
Extron India
+91.80.3055.3777
© 2016 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners. www.extron.com
Remove the end cap by
rotating the front away
from the enclosure.
Use a small
screwdriver to
release tabs in
3 places.
Reinstall end cap.
6
s
ma
ll
r
i
ver to
ta
b
s
i
n
es
Guide in front tabs.
Snap in rear tab
2
1
Cable Strain Relief
4
Cable Strain
Relief
5
Install the cable strain relief
and cover strips. The SMB 111
and SMB 112 do not require
the rear cover strip.
Route cables through the
rear access panel and attach
to the strain relief with a zip tie.
6a
6b
SMB 113 / 114 / 115
Slide out rear cover strip
and either discard or break
apart at the score marks
as noted.
Discard
SMB 111 / 112
Break at Score Marks,
Discard Middle
3
3
Rear Cabling