
4
OPERATING INSTRUCTIONS
EZIDRI ULTRA FD1000 DIGITAL
& SNACKMAKER FD500 DIGITAL
OPERATING INSTRUCTIONS
1. Connect to mains power supply Buzzer will ‘beep’ once with red light
2. Press Power Button to ‘ON’ Buzzer ‘beep’, display shows
Temp. 30ºC and Timer 1hr
Unit is now in ‘standby mode’
3. Set Temperature Adjust as required in 5°C increments
4. Set Timer Adjust as required in 1hr increments
5. Press Power Button Unit commences operating.
The Temperature setting (in 5ºC adjustments) and the Timer setting (in 1 hour
additions). For quick adjustment the buttons can be held down for rapid change for
both the Time & the Temperature.
Note: ULTRA FD1000 – At the completion of the ‘Time Set’ the unit will revert to 30ºC
and continue to operate until the unit is switched off. A feature to offset ‘re-hydration’.
SNACKMAKER FD500 – At completion of the ‘Time Set’ the unit will automatically
turn off. In the event of a power failure, the ‘Time Set’ and ‘Temperature’ feature will
restart automatically at the previously setting.
The Temperature and/or the Time, cannot be altered while the unit is running.
To change settings, press the Power button, unit will stop, then make any adjustments
to Temp. or Timer and then press the power button again to recommence operating.
6. To Turn the Unit Off Press the power button for 2 seconds
Unit will stop operating but red light
will show that the power is still connected.
1. TEMPERATURE SETTING ADJUSTABLE – FD1000 30 – 70ºC
FD500 30 – 60°C
2. TIMER ADJUSTABLE – FD1000 1 – 48hrs
FD500 1 – 24hrs
3. RED INDICATING LIGHT Indicates when
Power is connected
4. POWER SWITCH On and Off
Temp Time