Connecting a Pre-made Cable
Step 1: Strip away all of the cable and shielding so
you ha e 1/2" of the center conductor exposed as
shown in the picture.
Connect this end to
the camera.
Step 2: Then strip away the black outer jacket so
you ha e 1/4" of the shielding exposed. Do not
allow any of the copper shielding to touch the
center conductor.
Step 3: Insert the cable into the fitting and gently
find the hole for the center conductor before you
press the fitting onto the wire. Now just twist the
fitting onto the wire while firmly pressing down
until the fitting is firmly on the cable.
Installing a power wire pigtail
The cables are labeled with a yellow wrap detailing the camera end
and the DVR end. It is very important that you i entify these en s
before installing the cable so that you have the correct en s at the
correct location.
Installing a power wire pigtail
Step 1: At the camera location, take the power
cable and strip away the outer sheathing to expose
the inner two wires (black & red). Then strip away
about 1/4" of the wires jacket to expose the
copper wire. Do the same to the power wire pigtail
which connects to the camera power connection
as shown. Note: Do not strip or cut the power lead
coming directly from the camera. You should strip
the "pigtail" power cable which came with your
kit. You should ha e one "pigtail" for each camera.
Step 2: Now take the red power cable lead and
twist it together with the black & white lead from
the power pigtail. Now take the black lead from
the power cable and twist it together with the all
black lead from the pigtail. Use the gray wire nuts
pro ided with your system and twist them onto
the wires until they are firmly secured.
www.ezwatch-security-cameras.com
International 001-801-4783980
Main Office/Mailing Address
