Faber FCK 135 User manual

INSTRUCTION MANUAL
FCK 135
Read this manual thoroughly before using and save it for future reference
220-240V~ 50/60Hz
1850-2200W, 1.7L

1
IMPORTANT SAFEGUARDS
1. Read all instructions before using.
2. Before connecting the kettle to the power supply, check that
the voltage indicated on the appliance (underside the kettle
& base) corresponds with the voltage in your home. If this
is not the case, contact your dealer and stop using the kettle.
3. Do not let the cord hang over the edge of a table or counter or
touch a hot surface.
4. Do not place on or near a hot gas or electric burner or in a
heated oven.
5. Do not operate the appliance without anything in it to avoid
damaging the heat elements.
6. Ensure that the kettle is used on a firm and flat surface out of
reach of children, this will prevent the kettle from
overturning and avoid damage or injury.
7. To protect against a fire, electric shock or personal injury, do
not immerse cord, electric plugs or kettle in water or other
liquids.
8. While water is boiling, or just after the water has been boiled,
avoid contacting with steam from the spout.
9. Always take care to pour boiling water slowly and carefully
without tipping the kettle too fast.
10. Be careful of refilling when the kettle is hot.
11. This appliance is not intended for use by persons (including

2
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliances by a person responsible for their safety.
12. Children should be supervised to ensure that they do not
play with the appliance.
13. Do not touch the hot surface. Such as the handle or the
button.
14. The attached base cannot be used for other than intended
use.
15. Extreme caution must be used when moving an appliance
containing hot water.
16. The appliance is not a toy. Do not let the children play it.
17. The kettle is for household use only. Do not use outdoors.
18. The use of accessories, which are not recommended by the
appliance manufacturer, may result in fire, electric shock or
personal injury.
19. Unplug the kettle from the outlet when not in use and before
cleaning. Allow the kettle to cool before putting on or taking
off parts, and before cleaning the appliance.
20. To disconnect, turn any control to “off,” then remove plug
from wall outlet.
21. If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified

3
person in order to avoid a hazard.
22. Do not use the appliance for other than intended use.
23. The kettle can only use with the stand provided.
24. If the kettle is overfilled, boiling water may spill out.
25. Always ensure the lid is closed and do not lift it while the
water is boiling. Scalding may occur if the lid is removed
during the brewing cycles.
26. This appliance is intended to be used in household and
similar applications such as:
– Staff kitchen areas in shops, offices and other working
environments;
– Farm houses;
– By clients in hotels, motels and other residential type
environments;
– Bed and breakfast type environments.
27. Save these instructions.
This appliance can be used by children aged from 8 years and
above, if they have been given supervision or instruction
concerning use of the appliance in a safe way and if they
understand the hazards involved. Cleaning and user
maintenance shall not be made by children unless they are older
than 8 years old and supervised. Keep the appliance and its cord
out of reach of children aged less than 8 years old.

4
KNOW YOUR PLASTIC KETTLE
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended
that you should clean your kettle before use by boiling the Max
capacity of water once and then discarding the water. Wipe the
surface with damp cloth.
NOTE: The max capacity of kettle is 1.7L.
USING YOUR PLASTIC KETTLE
1. Place the unit on the level surface.
2. To fill the kettle, remove it from the power base and open the
lid by pressing the lid release button, fill with the desired

5
amount of water, and then close the lid. Alternatively, the
kettle may be filled through the spout. The water level should
not exceed MAX marks or sit below MIN level. Too little
water will cause the kettle switching off before the water has
boiled.
NOTE: Do not fill the water over the maximum level, as
water may spill out of the spout when boiling. Ensure that
the lid is firmly in place before plugging the power outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down the On/Off
switch, the indicator will light up. Then the kettle will start to
boil the water, once the water has being boiled the On/Off
switch will be off automatically. You can shut off the power
by lifting the On/Off switch at any moment during boiling
water. If you want to boil water again, only press down the
On/Off switch directly to restart the kettle.
NOTE: Ensure that the On/Off switch is free of obstructions
and the lid is firmly closed, the kettle will not turn off if the
switch is constrained or if the lid is opening.
5. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from
your kettle as boiling water may result in scald, besides,
don’t open the lid while the water in the kettle is hot.
6. The kettle will not re-boil until the On/Off switch is pressed

6
down again. The kettle may be stored on the power base
when not in use.
NOTE: Always disconnect the power supply when not use.
BOIL-DRY PROTECTION
Should you accidentally let the kettle operate without water, the
boil-dry protection will automatically switch off the power. If
this occurs, allow the kettle to cool before filling with cold
water to reboil.
CLEANING AND MAINTENANCE
Always disconnect the appliance from the power outlet and cool
it down completely before cleaning.
1. Never immerse the kettle, power cord or power base in water,
or allow moisture to contact with these parts.
2. Wipe the appearance of body with a damp cloth or cleaner,
never use a poisonous cleaner.
3. Remember to clean the filter at intervals. For easier cleaning,
detach the filter and then replace it after cleaning.
CAUTION: Do not use chemical, steel, wooden or abrasive
cleaners to clean the outside of the kettle to prevent the gloss
loss.
4. When not in use, the power cord can be stored at the bottom
of the appliance.
5. When not use or storage, the power cord may be wound under
the bottom of kettle.

7
REMOVAL OF MINERAL DEPOSITS
Your kettle should be periodically descaled as the mineral
deposits in tap water may form scale at the bottom of kettle
interior so as to cause the operation less efficiency. You can use
the commercially available descaler and follow the instructions
on the package of descaler. Alternatively, you may follow the
below instructions to use the white vinegar.
1. Fill the kettle with 3 cups of white vinegar, then adding water
to the amount so as to cover the bottom of kettle completely.
Leave the solution in the kettle overnight.
2. Then discard the mixture in the kettle, then filling the kettle
with clean water, boiling and then discard the water. Repeat
several times until the odor of vinegar has been flushed away.
Any stains remaining inside the spout can be removed by
rubbing with a damp cloth.
ENVIRONMENT FRIENDLY DISPOSAL
Dibuat untuk and diedarkan oleh:
FIMACO SDN BHD
8-2 WISMA FIAMMA No. 20, Jalan 7A/62A
Bandar Manjalara, 52200 Kuala Lumpur, Malaysia
Toll Free: 1800 282 09 , Website: www.faberappliance.com.my
You can help protect the environment!
Please remember to respect the local regulations: hand in the
non-working electrical equipments to an appropriate waste
disposal center.