Facina VKFCE1 User manual

INTRODUCTION
Congratulations on your purchase of this FACINA
product. This VKFCE1 is a high quality day / night camera
with LED illumination, varifocal lens, On Screen Display
programming & a sturdy cable managed mounting
bracket.
The camera can be used indoors or outdoors & has a
removable sun shield.
Please read this instruction manual carefully before
installation to ensure correct use of the product.
CONNECTIONS
PRODUCT FEATURES
* Sensor (CCD )
COLOUR 1/3" High Resolution CCD sensor.
* Auto Gain Control (AGC)
Built-in auto gain control (AGC) circuit. The colour cam-
era can achieve high quality images in low Lux conditions
* Auto Electronic Shutter (AES)
Built-in auto electronic shutter function. The colour
camera’s AES speed can reach 1/100,000s.
* Gamma Characteristic
Camera Gamma characteristic is 0.45.
* Scanning Mode
NTSC or PAL mode.
* Night-time Vision
0 Lux with IR LED ON. High quality IR LED’s provide
night-vision effect.
DC12V Power Supply
Monitor
VKFCE1
TROUBLE SHOOTING
Cable Cores：
Power
Video
Focus and Zoom
Screw Focus and Zoom
by Spanner.
Please tighten the cover
after focus and zoom to
prevent water ingress.
Note:
● Please note the camera’s operating temperature and its using
environment requirement. Avoid using the camera at too high or
too low temperatures. The operating temperature is -10℃-50℃.
(Recommendatory operating temperature is -5℃--40℃.)
● Never position the camera to face the sun or bright object. This
may damage the CCD.
● Do not mount the camera by a radiator or heater.
1. No Picture after providing power
. May be the power supply. please check the power supply voltage and polar-
ity.
. Please check all the connecting cables to monitoring equipment, especially
the ‘BNC’ connectors.
2. The picture shows ’rolling’ interference ripples
. May be caused by induced AC voltage on to video cables. Check for AC
cables near video cables & move as necessary.
. Check the earth potentials at monitor and peripheral equipments positions.
Earth potentials should be the same at each position.
3. The picture background colour changes continuously
. Fluorescent lamps or electromagnetic field can cause colour roll. This is a
normal phenomenon of the camera.
. Reduce the fluorescent lamp numbers or increase the distance between the
camera and the fluorescent lamps or electromagnetic field.
4. The picture ‘smear’s’
. The power supply’s voltage could be unstable.
. Cables not connected correctly or have high impedance.
To prevent fire or shock hazarded. Do not immerse the unit
The symbol is intended to alert the user to the presence of
The symbol is intended to alert the user to the presence of
into water.
important operating and maintenance (servicing)
Instructions in the literature accompanying the appliance.
uninsulated ‘dangerous voltage’ within the product’s
enclosure that may be of sufficient Magnitude to constitute
a risk of electric shock.
Notes：
●Please ensure the correct specification power supply is used. Check
voltage, polarity and operating temperature match the camera’s re-
quirement.
●Lightning protection is recommended for use with camera equipment.
If not installed, in electrical storms, camera equipment should be
disconnected.
●The BNC and Power Connections are not IP rated, please ensure that
these connections are suitably protected from water/moisture
ingress.
Video
12V DC
CAUTION:
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK
DO NOT REMOVE COVER OR BACK. NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING
RISK OF ELECTRIC. DO NOT OPEN
CAUTION:
To prevent electric shocks and risk of fire hazards,
do NOT use other than specified power source.

VKFCE1
Weatherproof Day& Night IR Colour
Camera
Specification
Model VKFCE1
Pick Up Element COLOUR 1/3″CCD
Effective Picture
Elements ( H*V ) 976×494
Horizontal Resolution 700 TV Lines
S/N Ratio
Clock Frequency (MHZ) 36
Scanning System 2:1 interlace
Minimum Illumination 0 Lux (with IR LED ON)
Synchronous System Internal, Negative sync.
Auto Electronic Shutter 1/50s~1/100,000s
Gamma Characteristic 0.45
Video Output 1Vpp,75 Ω
Auto Gain Control Auto
Power/Current 12VDC(±10%)/ 700mA
Lens 4-9 mm
Dimension (mm) 150(W)×100(H)×95(D)
Weight (g) 1100
Storage Temperature -30~ +60℃ RH95% Max
Operating Temperature -10~ +50℃ RH95% Max
More than 48dB
IR Distance Up to 30 Meters ( with 35 Unit Infrared LED)
IR Status Under 10 Lux by CDS
IR Power On CDS Auto Control
Water Resistance IP66
Packing List
No Name Model Number
2. User Guide 1
1. WeatherProof Day& Night Colour IR
Camera
VKFCE1 1
Notes: Please read this User Guide in
detail prior to installation
Do not attempt to disassemble the camera.
If the camera does not function correctly,
please contact our technical helpline on Tel:
01253 792898
Challenger Security
10 Sandersons Way
Blackpool Lancashire
FY4 4NB
Tel: [phone]
Fax: [phone]
Email: [e-mail]