Factor Electronics V-66-Wi-Fi User manual

V-66-Wi-Fi Installation Instructions
Wi-Fi to RS232 Media Controller
Specifications are subject to change ithout notice .factorelectronics.com
Complete the following steps first:
1. Do nload the V-66 app on your PC or mobile device.
Search “Factor V-66” on the iTunes App store for IOS.
E-mail “[e-mail]” for the Android app.
2. Connect the V-66 Wi-Fi to the V-66 using the included DB9 cable. Connect the antenna and
po er supply to the V-66-Wi-Fi unit. Po er On both the V-66 and the V-66-Wi-Fi.
3. You must have a MAC or PC connected to the LAN and rite do n the LAN pass ord to
complete the setup as follo s:
Search available net orks and click on MAP-1200HD Open a bro ser and enter 10.10.100.254 in the top bar. Click “OK”
Select your language of choice Change AP Mode to STA Mode. Click Apply

V-66-Wi-Fi Installation Instructions
Wi-Fi to RS232 Media Controller
Specifications are subject to change ithout notice .factorelectronics.com
Click search, find your net ork, highlight your net ork, click apply The net orks page ill close no enter your net ork pass ord
Net ork pass ords
are case sensitive.
Click apply after
entering your pass ord
Click RESTART to reboot the V-66-Wi-Fi once the settings are complete
After the RESTART
all lights ill go out
for 3 sec
Once the RESTART
Is complete there
ill be one red and
t o green lights lit
Note: if the V-66-Wi-Fi restarts ith only t o lights, one red and
one green light you must repeat the setup process. Check your
pass ord and make sure it's correct. You can manually REBOOT
The V-66-Wi-Fi by holding do n the inset button for 10 sec . The
inset button is located beside the DC po er inlet.
Launch the app 1, 2or 3 unit control Select a zone to control Zone on or all zones on Select a source
Control volume Control treble/bass Touch & name a source Touch & name a zone Select party mode