Factor HORN-15 Instruction Manual

Thank you very much for choosing the FACTOR Electronics HORN-15. Please follow these
instructions carefully to ensure proper installation and operation. If you have any questions about
this product please contact Factor Electronics at [email protected]
Installation:
1. Careful attention should be paid to the polarity of each HORN-15 when more than two
HORN-15’s are used in the same area. Keep the polarity the same on all HORN-15’s for the
best results.
2. Connect the BLACK wire to the common or negative terminal of the amplifier.
3. Connect the WHITE wire to the positive 25V,
or 70V terminal of the amplifier.
4. Wire multiple HORN-15’s in parallel.
5. When long wiring runs and multiple HORN-15’s are necessary always use a high impedance
25V or 70V amplifier.
6. For low impedance connections, the total impedance of speakers should be equal to output
impedance of amplifier.
7. When connecting multiple HORN-15’s to a single 25V or 70V amplifier the total speaker
wattage should never exceed the wattage rating of the amplifier. In fact we recommend
using 30% headroom.
Example: Connect 10 x HORN-15’s in parallel and set the wattage tap selector to 15 watts 70V
on each HORN-15. Add up the total wattage
10 x 15 watts =150 watts then add 30%.
150 x 1.3 =195 watts. Use an amplifier with a minimum of 195 watts @ 70V.
8. When setting the power tap switch , be certain
to use the proper positions for either 25V or
70V systems , to prevent horn damage.
Changing impedances:
See the instructions on the HORN LABEL

H-Mounting Bracket
Specifications
MODEL
HORN15
Rated input
Power
15 W
(70V,25V Line)
input
impedance
42W(25V Line only)
63(25V Line only)
170(25V Line only)
330




Preset impedance
330
Frequency response
280~12.500HZ
Sound Pressure level
108dB 1/W/1M
Dimensions
Horn Flare :
Length :
HORN15
Aluminum
Φ212.5mm
229.5mm
Specifications are subject to change without notice.
Contact Information
FACTOR ELECTRONICS
4159 McConnell Drive Burnaby B.C. Canada V5A-3J7
E-mail: [e-mail]
Website: www.factorelectronics.com
Warranty
FACTOR ELECTRONICS products are warranted to be free from defects in workmanship and
materials for a period of one (1) year without charge for parts or labor. The warranty applies
only to the original owner. The owner’s responsibilities are to provide proof of purchase and
transportation to the dealer the unit was purchased from or transportation to FACTOR
ELECTRONICS This warranty does not apply to units which have been subject to misuse,
abuse, neglect or improper installation, and does not apply to repairs or alterations by
unauthorized personnel. This warranty specifically excludes responsibility for consequential
damage.
Retention of your dated ORIGINAL BILL OF SALE is required to obtain service under the terms
of the warranty.