Fadisel cebek TF-3 User manual
SUPPLEMENTARY
RING to 230V
TF-3
TECHNICAL CHARACTERISTICS
Voltage...........................................230V AC.
Maximum power..............................250W AC.
Minimum power...............................50W AC.
Interference protection....................Yes
Activates t e triac output w ile t e p one bell rings.
230V direct operation wit out using power.
Suitable for connecting ig -power ring or indicator lig ts in factories and local noise environment.
CONNECTIONS
Output 230V
Input 230V
P one line
IMPORTANT: Do not touc t e circuit being connected to t e mains as t ere 230V at various points of it.
www.cebek.com - sat@cebek.com
c arge
www.cebek.com - sat@cebek.com
TF-3
EXAMPLE OF INSTALLATION
T en we put a practical example of a supplementary installation of t e p one ringing.
In t e drawing is represented a bulb but can connect any type of warning eit er acoustic or lig t as long as
consumption is in t e 50W and 250 as minimum and maximum
INSTALLATION TIPS
For proper operation of t e module, follow t ese tips:
Install t e module in a plastic box preferably.
Take care not to leave any part of t e module accessible from t e outside, as t ere is 230V. in various parts of it, wit
t e attendant risk of electric s ock.
To connect t e circuit to t e telep one line, we recommend using a standard connector as used in telep ony.
VERIFICATION CIRCUIT
C eck t at all connections are correct. Connect t e circuit to t e mains. From t is point extreme caution in andling,
to avoid unpleasant s ock.
Have someone call you. W en you ear t e p one make sure t e lig t bulb goes on and off every time t e doorbell
rings. At t e time of pick up t e p one t e bulb will go off completely.
NOTE: T e circuit can be installed anyw ere in t e telep one network, for example can ave t e p one in a room
and t e circuit in anot er
P one box
Output max
250W
Input 230V
Table of contents
