Falcon DOMINATOR PLUS E3478 User manual

E3478 DOMINATORPLUS
Steaming Oven
USERS INSTRUCTIONS
SECTION 1 - GENERAL DESCRIPTION
SECTION 2 - CONTROLS and OPERATION
SECTION 3 - COOKING HINTS
SECTION 4 - CLEANING and MAINTENANCE
This appliance has been CE-marked on the basis of compliance with the Low Voltage and
EMC Directives for the voltages stated on the data plate.
The appliance MUST BE installed by a competent person in compliance with the INSTALLATION AND
SERVICING INSTRUCTIONS and National Regulations in force at the time.
UK regulations are listed on the front of the Installation and Servicing Instructions.
Regular servicing by a qualified person is recommended to ensure the continued safe and efficient
performance of the appliance.
WARNING - THE APPLIANCE MUST BE EARTHED.
Upon receipt of the User's Instruction manual, the installer should instruct the responsible person(s)
of the correct operation and maintenance of the unit.
This equipment is ONLY FOR PROFESSIONAL USE, and shall be operated by QUALIFIED persons.
It is the responsibility of the Supervisor or equivalent to ensure that users wear SUITABLE
PROTECTIVE CLOTHING and to draw attention to the fact that, some parts will, by necessity, become
VERY HOT and will cause burns if touched accidentally.
WEEE Directive Registration No. WEE/DC0059TT/PRO
At end of unit life, dispose of appliance and any replacement
parts in a safe manner, via a licenced waste handler.
Units are designed to be dismantled easily and recycling of all
material is encouraged whenever practicable.
Falcon Foodservice Equipment
HEAD OFFICE AND WORKS
Wallace View, Hillfoots Road, Stirling. FK9 5PY. Scotland.
SERVICELINE CONTACT
Phone: [phone] Fax: [phone]
T100790 Ref. 1

SECTION 1 -
GENERAL DESCRIPTION
The unit consists of a stainless steel oven chamber with
side-hinged door. Water well is situated in chamber base.
Water enters well from a rear mounted cistern and the
level is automatically controlled by a ball valve in cistern.
Water in well is heated by three immersion elements.
These are controlled by a switch on lower front panel of
unit. Three heat settings are available:-
Low (1)
Medium (2)
High (3)
The oven has a steam vent in chamber roof and a drain
valve in lower cabinet. A smaller drain valve is located in
drip trough directly below oven door.
Warning: When opening door during normal operation,
steam will escape.
Water Level
Unit must be installed with a stopcock on water supply
cistern. THE OVEN SHOULD NEVER BE USED EMPTY!
Open stopcock to fill water well through cistern located at
unit rear. Filling will stop automatically when depth in well
reaches 70mm. Water level mark indicated at well rear.
When oven control is ON, water will heat. When boiling,
well automatically tops up to maintain correct water level.
Stopcock must be turned ON at all times while in use.
If stopcock has been left closed open during operation,
the well will boil dry. This could result in serious damage
to elements.
Oven Hangers, Shelves and Containers
Two identical hangers locate upon studs near top of
chamber.
Six perforated aluminium shelves are supplied.
These slide upon hanger runners. Any number of shelves
or containers - up to a maximum of six may be used,
according to requirements.
A 1/1 gastronorm container may be placed on each shelf.
Vent to atmosphere
Single action
door lock pin
(two stage action
option available)
Drip trough
drain cock
Drain cock
Removable
door trough
Power indicator (red)
Heat indicator (amber)
3 position switch control

SECTION 2 -
CONTROLS and OPERATION
Switching On
Ensure water stopcock is turned ON and that water well
is filled to correct level.
Turn power on at main switch (external to appliance) and
turn control knob to Position 3 (HIGH) for rapid heating.
Amber neon will illuminate to indicate that power is being
supplied to elements. Red neon will illuminate when main
switch is ON to indicate connection to electricity supply.
Heating Up
With control at HIGH setting (3), close oven door and
allow compartment to heat up for 15 to 20 minutes until
steam emits rapidly from top vent.
Oven is now ready to use, turn control down to LOW
position (1) until food is ready to be loaded.
SECTION 3 - COOKING HINTS
Cooking
1. Load with food as required. It is always preferable to
spread load over several shelves rather than place it all
on one.
2. Close oven door. Turn to HIGH setting (3).
3. When steam is once again emitting rapidly from vent
reduce heat to Setting 1 or 2 and maintain cooking
without undue waste of steam.
Food Loadings
45kg (maximum) of potatoes may be cooked.
These should be spread evenly over the six containers.
16kg (maximum) of steamed puddings may be cooked in
individual moulds. These should be spread evenly over
the six shelves.
SECTION 4 -
CLEANING and MAINTENANCE
Important
BEFORE ANY CLEANING IS UNDERTAKEN, ISOLATE
POWER SUPPLY FROM MAINS. THE APPLIANCE
MUST NOT BE CLEANED WITH A JET OF WATER.
The oven chamber should be cleaned daily, immediately
after completion of work whilst unit is still warm.
Turn heating control and water stopcock off.
Open lower door and drain well and cistern contents into
bucket or similar vessel. Note: Contents of well are
greater than one bucketful.
Remove containers, shelves and hangers.
Wipe down inside of oven compartment using a cleaning
cloth and suitable detergent.
Close drain valve and refill boiler well. Drain contents
once again and dry compartment interior thoroughly with
a clean cloth. Drain drip trough directly below oven door
and clean it out.
It is advised that oven well be left empty in readiness for
the next day's work. An arrangement should be made to
check that unit is not switched on when chamber well is
empty.
SECTION 5 - SPARE PARTS
Door seal
Door handle
Door pin (single action)
Door pin (double action)
Drip tray
Control knob
Shelf