Fast Lane NEBULA CRUISER User manual

NEBULA
CRUISER
The Nebula cruiser is a 2 ft. long R/C quadcopter constructed of durable
lightweight materials. It is extremely stable, maneuverable and capable
of performing barrel rolls in midflight.
Model no. 5F63DFB

PLEASE READ ALL INSTRUCTIONS CAREFULLY AND PRIOR TO FIRST USE
CAUTION:
For ages 14+.
CHOKING HAZARD –SMALL PARTS. Keep away from children.
Keep Drone at least 6 ft. away from other objects while in flight.
Never fly the Nebula Cruiser near people or animals as this may result in injury.
Do not fly in winds in excess of 4 mph.
Do not expose any part of the Nebula Cruiser or remote to water or moisture.
Only use the Lithium battery included with this kit in the Nebula Cruiser.
Never leave the charging battery unattended.
Only charge the battery in a clean, dry and cool location away from children.
Do not expose batteries to heat or water.
Remove and disconnect all batteries when not in use.
Recycle batteries according to State and local regulations.
Do not use battery if the surface temperature feels hot or exceeds 104 degrees.
Allow battery to cool prior to use or prior to charging.
Do not use battery if it is damaged.
Nebula Cruiser
1

Remote Battery Installation:
Lithium Battery Removal and Charging Instruction:
The lithium rechargeable battery pack that will need to be charged before first use.
Charge Time = approx. 30 min. Fly Time = up to 10 min.
Step 1 –Open battery compartment located at top center of Nebula Cruiser.
Gently remove battery and disconnect cords.
*Be careful not to pull or twist cords as this could damage the connection.
Step 2 - Plug the lithium battery into the USB Charging Cable, then into USB wall adapter or USB port on your computer.
Insert 4 AA Batteries according to the
polarities marked inside the battery
compartment
2

Charging continued…
* A red indicator light will illuminate on the USB plug to show that a charge is occurring.
Never leave battery unattended while charging.
Step 3- The red indicator light will turn off once full charge has been achieved. Do not charge the
battery beyond this point.
Step 4 - Disconnect USB cable from all connections.
Step 5 –Reinsert lithium battery into Nebula being careful when handling the cords. Reattach battery compartment door.
Flying the Nebula Cruiser:
1. Move power switch on the Cruiser to the "ON" position.
2. Move power switch on the remote to the "ON" position.
* Tip - Make sure the throttle lever is at the lowest position.
3. Place cruiser on a flat, level surface with front facing in the same
direction you are.
4. Synchronize remote to the Cruiser by moving the left speed
control lever maximum up and maximum down in one movement.
The remote will beep once and the Cruiser lights will stop blinking if
sync was successful.
Move left speed control stick slowly
upward to desired altitude
Move left speed control stick slowly
downward to land
Move the right direction control stick
left or right to move cruiser clockwise
or counter clockwise.
While ascending, move the right
direction control stick forward,
backward, left or right to control
direction of flight.
3

Flip Control:
*Tip - Make sure the nebula cruiser is hovering at least 9 feet from the ground before attempting flips.
While hovering, move directional control stick in any extreme direction and press the flip button.
Nebula Cruiser will flip in the direction that the joystick is pointed.
Trimming and calibrating:
Flight adjustments may be needed depending on environment, ground surface, wind, etc.
To trim and calibrate your Nebula Cruiser, run these tests and make adjustments just as your aircraft
becomes airborne (within 12" from the ground).
1. To correct spin, slowly tap the "Direction Trim" switch in the direction you wish the Nebula Cruise to go.
2. To correct forward or backward movement, tap the "Forward and Backward Trim" switch in the direction you want the
Cruiser to go. Tap the “Trottle Trim” switch to accomplish same forward or backward movement.
3. To correct excessive movement to the left or right, tap the "Side Trim" switch in the direction
you want the Nebula Cruiser to go.
Troubleshooting:
Issue
Solution 1
Solution 2
Solution 3
After trim adjustments, craft
continues to fly sideways or
out of control
Check to make sure
propellers are assembled
onto correct motors.
Check to make sure no hair,
string, etc. is caught in the
propeller
Check propeller to make sure
they turn freely and are not
damaged
Aircraft does not take off
Reset syncronization (see
instr. pg. 3)
Install fully charged batteries
into drone and remote
Make sure you are within the
12 feet range and there is not
obstruction or interference
After hard landing, propeller
does not spin
Inspect propeller and
replace any propeller
that is damaged
If propeller does not turn,
there may be damage to the
rotor. Contact manufacturer
for replacement
Replacement parts are available for purchase directly from the dealer or at
www.Odysseytoys.com
For additional questions or support please contact [email protected]
4