feather&black Bedrooms User manual

Step By Step Assembly Instructions
Pre-assembly Preparation
PLEASE READ these instructions fully prior to assembly to familiarise yourself with the various
stages of construction.
Carefully open all packs supplied and check the contents against the parts and fittings check list.
Do not destroy any of the packaging until you are certain that you have all the necessary parts for
the assembly.
This product is HEAVY, it should be assembled as near as possible to the point of use.
Take care when lifting to avoid personal injury and (or) damage to the product.
This product takes approximately 30 minutes to assemble by a minimum of two people.
Please ensure that the packaging is disposed of in a safe environmentally friendly way.
There are small components used in the construction of this bed as well as plastic foil packaging,
these should be kept away from young children whilst assembling your bed.
Assembly tool and instructions
Note: Throughout the assembly instructions the
headboard and feet shown may vary depending
up on the customer choice.
819/03/13

2
Z
Y
X
X
W
V
V
T
T
T
T
S
S
V
V
U
HeadboardZ1
FootboardY1
Part identification Qty
Side panelX2
Centre railW1
LegsV4
Slats
Corner brackets
Centre rail brackets
U
T
S
32
16
Double bed +
Single bed
4
2
Double bed +
Single bed
Plastic slat clips
Spare plastic slat clip
13mm ring spanner
N
M
L
Fittings list Qty
64
32
1
1

3
Note: Ensure that the side panels are
pushed fully down with the bolt heads
located to the top of the slots.
Note: Begin with the headboard.
10mm
(3/8")
Y
V
V
X
X
step1
Unscrew the bolts on the headboard and footboard by approximately 10mm (3/8”).
While holding the headboard upright,hook the side panels onto the bolts.
Hook the side panels onto footboard, hand tighten all the bolts.Ensure that the bed is square (90° at all
corners) then tighten all of the bolts fully on the headboard and footboard, using the ring spanner supplied.
step2
L
x1
Note: On legs where an additional
locating screw is supplied, please fit
to hold legs square to the corners.
Attach the legs to the headboard and footboard.
Fittings
Z

4
W
step3
step4
Fit the centre rail hook into position on the headboard, then footboard and
then push down to secure.
Adjust and tighten wing nut on the underside of the centre rail brackets.
Starting at the headboard end, fit the slats (centre of the slat to curve upwards), into
the first plastic clip on either side, fit centre plastic clips to the slat ends, push down
into the holes on the centre rail. Repeat with remaining slats.
U
Your bed base is now
complete and ready to use.
Please keep these instructions
for future reference.
Assembly Helpline: 01159 737070
N
x32
Fittings