FEB Easy 9320/K User manual

9320/K – Pulsante da portachiavi senza li
1- Safety warning
Warning: Failure to follow the safety guidelines provided below could result in damage to your
Wireless Pushbutton or other property. Read all safety information below before using the Wireless
Button.
• Avoid high humidity or extreme temperatures;
• Avoid prolonged exposure to sunlight or intense UV light;
• Do not drop or do not subject the unit to strong vibrations;
• Do not disassemble or try to repair the unit;
• Do not bring into contact with ammable liquids, gases and other explosive substances.
2 – Benvenuti
We present your Wireless Button 9320/K.
This button is self-powered by a small piezoelectric circuit and allows you to control the actuators of
the FEB Easy series without ever having to worry about changing the batteries.
It is possible to use a single button to control more than one actuator and to use several buttons to
control the same actuator.
In this guide you will nd an overview of the product and instructions for installation and start-up.

3 - A detailed look at your device
Your wireless pushbutton 9320
Button: the part to press to send a signal
Keychain hole: you can use this hole to hook the button to a keychain or a lanyard
4 - Installation
The 9320/K button does not require installation: it is designed to be always portable, thanks to its
small size and the keychain hole.
5 – Start up
To pair the 9320/K to an actuator, simply press the actuator pairing button for about 3
seconds, until the LED indicator starts ashing, at this point press the 9320K button. Just
press once. You will see that the actuator LED will stop ashing, indicating that the two have
been paired. It is possible to connect more than one button to the same actuator, up to a
maximum of 10 buttons. There are no limits, instead to the number of actuators that can be
controlled by the same button, simply repeat the pairing procedure between the button and
all the actuators that you want to be controlled by the same button.
To reset a connection between the actuator and the button, press the actuator pairing
button for about 12 seconds. When the button is pressed, the LED indicator will rst begin to
ash, it will remain lit briey and then go off. When this sequence is complete and the LED is
off, the pairing button can be released and the actuator and all the buttons it was paired
with will be disconnected.

6 – Technical Characteristics
Wireless network: RF 433MHz
Operating distance: Indoor <= 25m / Outdoor <= 60 m
Operating temperature: -5 - 50°C
Dimensions: 21 x 51.6 x 18.5 mm