Fender HAMMERTONE DISTORTION User manual

INPUT JACKOUTPUT JACK
9V BATTERY SCREW ACCESS ON REAR
DC POWER CONNECTOR
FOOTSWITCH
LED

Thanks for purchasing the Hammertone
Distortion—a no-nonsense stompbox effect that
boosts your sound to new heights of dirt, grit and
power.
Dial in distortion character with treble, bass, gain
and level controls, and use the internal trim
potentiometers to tailor distortion sounds even
more. Distortion is an indespensible effect in the
arsenal of any guitarist and bassist, and the
Hammertone Distortion puts this eminently
satisfying effect at your feet in every shade from
subtle to seismic.
HAMMERTONE DISTORTION

OUTPUT JACK
Low-impedance output connects to amp or next pedal in signal chain.
INPUT JACK
High-impedance input for electric guitar, bass, acoustic guitars with
pickup systems, keyboards and other instruments.
DC POWER CONNECTOR
Connect DC adapter here. Standard center-negative 9VDC jack for use
with appropriate power supplies.
TREBLE CONTROL KNOB
Adjusts treble frequency level.
BASS CONTROL KNOB
Adjusts bass frequency level.
LEVEL CONTROL KNOB
Adjusts volume of distortion effect.
GAIN CONTROL KNOB
Adjusts gain level from a low-gain overdrive to full-blown high-gain
distortion.
LED
Illuminates when effect is on.
FOOTSWITCH
Turns effect on and off.
BATTERY COMPARTMENT (REAR)
Screw-access compartment houses one 9V battery.

INTERNAL TRIM POTENTIOMETERS (ACCESSIBLE BY
REMOVING COVER)
MIDRANGE trim pot is an EQ cut/boost control and is flat when set in
the center.
FILTER trim pot is a low-pass filter that helps remove excess high-
frequency energy or “fizz” (around 4kHz and higher) from
brighter-sounding amplifiers.
Remove cover using a flat-head screwdriver. Adjust trim pots using a
Phillips-head screwdriver.
MIDRANGE TRIM POT
FILTER TRIM POT
9V BATTERY
(NOT INCLUDED)

A PRODUCT OF
FENDER MUSICAL INSTRUMENTS CORPORATION
CORONA, CALIFORNIA, U.S.A.
Fender®is a registered trademark of FMIC.
Copyright © 2021 FMIC. All rights reserved.
PN 7724430000 REV A
IMPORTANT SAFETY INSTRUCTIONS
•WARNING: To prevent damage, fire or shock hazard, do not expose the unit or its AC
power to rain or moisture.
•Do not alter the AC plug of the connected power adapter
•Do not drip or splash liquids on the unit.
•No user serviceable parts inside, refer servicing to qualified personnel only.
•WARNING: The unit must only be connected to a safety agency certified, regulated,
power source (adapter), approved for use and compliant with applicable local and
national regulatory safety requirements.
•Unplug the AC power adapter before cleaning the unit exterior. Use only a damp cloth
for cleaning and then wait until the unit is completely dry before reconnecting it to power.
•Amplifiers and loudspeaker systems, and ear/headphones (if equipped) are capable
of producing very high sound pressure levels which may cause temporary or permanent
hearing damage. Use care when setting and adjusting volume levels during use.
ADDITIONAL LANGUAGES
Manual available in additional languages at
www.fender.com/support
Product specifications subject to change without notice
SPECIFICATIONS
IMPEDANCES
POWER SUPPLY
POWER REQUIREMENTS
DIMENSIONS
WEIGHT
Input: 500kΩ Output: 470Ω
9VDC regulated adapter,
5.5 x 2.1 mm barrel connector, center negative
80mA @ 9VDC
2.44” x 4.4” x 2.2” (62mm x 111.8mm x 55.9mm)
0.55 lbs (0.25kg)

© FENDER MUSICAL INSTRUMENTS 2021