Fenix CL20R User manual

Fenix CL20R Camping Lantern
Technical Parameters
General Mode Red lantern
Turbo High Med Low Flash Constant
on
utput
300 Lumens 130 Lumens 40 Lumens 1 Lumen — 1.5 Lumens
Runtime
6h 12h 20h 200h / 100h
Beam Diameter 15m (Max)
Waterproof
IP66

Impact Resistance
1.5m
The abovementione parameters (lab-teste by Fenix using 1600mAh Li-polymer battery) may vary
between lanterns, batteries an environments.
16 neutral white LED’s plus 2 re LED’s, even an smooth beam
White lantern: 4 output levels; re lantern: 2 output levels
Max 300 lumens an 200 hours runtime
Built-in 1600mAh Li-polymer battery
Magnetic bottom an hanging loop
72mm Length x 41.5mm Wi th x 50mm Height
91 grams
Digitally regulate output maintains constant brightness
Single electronic switch for fast an convenient operation
Ma e of quality plastics an high transparent material - smooth anti-glaring beam
IP66 rate protection
perating Instruction
White lantern
N/ FF
Press an hol the switch for 0.5
secon s to turn on/off the lantern.
utput Selection
Single click the switch to cycle through
Low→Me →High→Turbo (Low is
factory efaulte )
Red lantern
N/ FF
With the lantern turne on, ouble click to enter re lantern, ouble click once again to return to
white lantern. Press an hol for 0.5 secon s to turn off the lantern.
utput Selection

Single click the switch to cycle through Constant on→Re Flash (Constant on is factory efaulte )
Charge
1. Remove the anti- ust cover to reveal the charging port of the camping lantern an plug the Micro
USB terminal of the charging cable into it.
2. If the battery level is fairly sufficient, the charging in icator isplays green to in icate unnecessary
charging. Or the charging in icator will isplay re while charging, an will turn to soli green when
fully charge . The normal charging time of the built-in 1600mAh battery is approximately 1 hour an
40 minutes from out of power to fully charge with the light off.
3. Once charging is complete , be sure to remove the charging cable an replace the anti- ust cover
to maintain the waterproof ability.
*The lantern can only be use on Low an Me output when charging, but the charging time will be
prolonge .
Battery Level Indication
When the lantern is turne off, single click the switch, the battery level in icator on the si e switch
will isplay the battery status for 3 secon s.
Green light constant-on: saturate , more than 85%
Green light flashes: sufficient, 85%-51%
Re an green flash alternately: poor, 50%-21%
Re light flashes: critical 20%-0%
(These are approximate figures.)
Parts Included
1. 1*CL20R camping lantern
2. 1*USB charging cable
3. 1*User manual
4. 1*Warranty car
Usage and Maintenance
Fully charge the lantern timely to guarantee the next normal use.
Recharge a store lantern every three months to maintain optimum performance of the battery.
Warning
This lantern is a high-intensity lighting evice capable of causing eye amage to the user or
others. Avoi shining the lantern irectly into anyone’s eyes.