ferm living Gry Table Lamp User manual

Assembly manual
Gry Table Lamp

General Instructions
PLEASE READ BEFORE INSTALLATION
WARNING:
The safety of this fitting can only be guaranteed if the following instructions are observed during both
installation and use. Please retain these instructions safely after installation.
PLEASE OBSERVE THE FOLLOWING GUIDELINES:
– Ensure that the power supply has been switched o prior to installation or removal of the product.
– Never undertake an electrical installation without the proper knowledge or training. If not familiar
with electrical wiring, contact a qualified electrician.
– The product may in no way be modified or tampered with. Any modification may compromise safety
and make the product itself dangerous to use. FERM LIVING does not accept any responsibility for
products that have been modified.
– The light source contained in this luminaire shall only be replaced by the manufacturer or his service
agent or a similar qualified person.
– Please charge the battery before initial use.
CLEANING INSTRUCTIONS:
– Use only a soft cloth to clean the product. Dampen the cloth with water and soap or a mild cleanser
if needed.
MORE INFORMATION:
To access further information such as product overview and material descriptions, please visit our
website at www.fermliving.com. If you have any questions or comments, please do not hesitate to
contact us at [email protected].
Technical Specifications
GRY TABLE LAMP:
Voltage: 100-240V - 50/60Hz
Dimmable: 3W, 3 steps touch dimmer.
Light spcification: 3000K warm white, CRI >80. 240lm
Battery Capacity: 3.7V, 5200mAh
Charging Time: 6-8 hours. Discharging Time: 8-24 hours
Cable: 1.2 m USB cable type C
Certification: IP44, Class III, CE, UKCA, ETL, CB, RoHs
Needed adapter specification: 100 - 240V, 5V DC/2A output. Adapter not included.
Recommended light souce: Non removable dimmable LED
2

Box Content
1x
3-way touch switch
1x
1.2 m USB cable type C
1x
Base
1x
Shade
3

1
Assembly Process
Remove the plastic protector
4

2
Assembly Process
Unscrew the 3-way-touch-switch
5

3
Assembly Process
Mount the shade onto the base, and screw back
the 3-way-touch-switch to fix the shade
6

7

fermliving.com