Ferm FLYING SPHERE User manual

FLYING SHELF - SPHERE
ASSEMBLY MANUAL
fermliving.com
NOT SUITABLE
FOR PLASTER
WALLS!

CONTENT OF THE BOX
1 x Shelf
L: 600 x W: 175 H: 2.66 mm
1 x Cylinder accessory
1 x Sphere accessory
4.
Now; make sure that the shelf is level. Raise the
right side of the shelf up to the previously marked
B. It is possible that you will have to correct the
mark slightly. Use a spirit level for measurement.
3.
Mount the shelf to the sphere accessory by inserting
the small screw beneath the sphere. The shelf should
be placed in between the sphere and the screw.
Use the small hex key to tighten the screw.
2.
Start by drilling hole A (drill size Ø10).
Make sure that you drill straight into the wall
in a 90 degree angle. Insert rawlplug in the
hole. Screw the large screw into the wall by
using a screwdriver with a 6-star bit. Rotate
the sphere accessory onto the screw.
5.
When the shelf is level, drill hole B (drill size Ø8) and
insert rawlplug in the hole. Make sure that the shelf
is raised above the hole before screwing the medium
screw into the wall by using a screwdriver with a 6-star
B
5.
Rotate the cylinder accessory onto the screw.
6.
Lower the shelf down on the cylinder, so that it ends up
resting on it. The Flying Shelf is now mounted correctly.
Mark the holes with a pencil
90
A
B
90
1 x Life-sized measuring paper
1 x Small screw + Small hex key
1 x Medium screw + rawlplug (hole B: / drill size Ø8)
1 x Large screw + rawlplug (hole A: / drill size Ø10)
PLEASE NOTE :
THE MOUNTING
PROCESS REQUIRES
2 X PEOPLE
AB
NB!
MAX. LOAD 5 KG
ASSEMBLY PROCESS
1.
Use a good position on the
wall. Ensure that the mark-
ings are on the bricks of the
wall and not the sealant.
Use the enclosed life-sized
measuring paper to mark
the holes Aand B:
Hold the paper against the
wall and make sure that it
is level. If needed; tape the
measuring paper to the wall.
Punch trough the paper
with a pencil to mark the
placement of the two holes.
WARNING:
Different wall materials require
different types of rawlplugs or
fixing devices. For advise on suit-
able fixing systems, contact your
local specialized dealer. Rawlplugs
enclosed are inted for brick wall.
NOT SUITABLE
FOR PLASTER
WALLS!
1 : 1 measuring paper