Festo MS6-WPG Assembly instructions

Translation of the original instructions
1 Applicable documents
All available documents for the product èwww.festo.com/pk.
Document Product Contents
Instructions MSE6-C2M Operating, Control and Condition Monit-
oring Module
Instructions MSE6-D2M Operating, Energy Efficiency Module
Description MSE6-E2M Assembly, Installation, Commissioning,
Energy Efficiency Module
Tab. 1
2 Safety
2.1 Safety instructions
– Only assemble the product on components that are in a condition to be safely
operated.
2.2 Intended use
Wall mounting of maintenance device modules and service unit
3 Product range overview
3.1 Scope of delivery
Wall mounting kit MS6-WPG:
1Wall mounting(1x)
2Module connector(1x)
3O-ring(1x)
Fig. 1
3.2 Not in scope of delivery
Module connector MS6-MV-EX:
4Module connector(1x)
(rear)
5Module connector(1x)
(front)
6O-ring(1x)
Fig. 2
4 Mounting
4.1 Mounting positions
• Depending on the configuration, mount the wall mounting kit between the fol-
lowing service units and the service device modules.
Product Type Mounting position
Wall mounting kit MS6-WPG black box
Service unit MSE6-D2M [A]
MSE6-E2M [B]
MSE6-C2M...(-M) [C]
Service device module MS6-... [D]
MS6-SV-D [E]
Tab. 2
4.1.1 Positions with service unit[A]/[B] and modules[D]
Fig. 3
4.1.2 Positions with service unit[A]/[B] and modules[D]/[E]
Fig. 4
4.1.3 Positions with service unit[C] and modules[D]
Fig. 5
4.1.4 Positions with service unit[C] and modules[D]/[E]
Fig. 6
4.2 Assembly
NOTICE!
Incorrect electromagnetic compatibility if incorrect module connectors are moun-
ted.
• Use only module connector MS6-MV-EX.
Mounting with example of MSE6-E2M[B]:
Fig. 7
1. Remove earth cable[F] from earth terminal[G].
2. Remove module connector2 from the wall mounting1.
3. Remove sub-base[H] from the service unit[B].
8105041
MS6-WPG
Wall mounting-Set
8105041
2019-01b
[8105043]
Instructions|Assembly
Festo AG & Co. KG
Ruiter Straße 82
73734 Esslingen
Germany
[phone]
www.festo.com

Fig. 8
• Place O-ring6 between the service unit[B] and the service device mod-
ule[D].
Fig. 9
• Mount module connector2 on the wall mounting1. Tightening torque:
1.2Nm ± 10 %
Fig. 10
• Place O-ring3 between the two service device modules[D].
Fig. 11
• Mount module connector5 on the module connector4. Tightening torque:
1.2Nm ± 10 %
Fig. 12
1. Place wall mounting1 on the service device module[D].
2. Place sub-base[H] on the interface of the service device module[D].
Fig. 13
• Mount module connector2 on the wall mounting1. Tightening torque:
1.2Nm ± 10 %
Fig. 14
1. If necessary, replace the included earth cable[F] with a longer earth cable.
2. Connect the earth cable[F] to the earth point[G] again. Tightening torque:
2Nm ± 10 %