FIBERNET LADY User manual

OPERATING MANUAL
LADY | ELECTRIC MOTOR
How to use your
electric motor in few steps

1.TECHNICAL
FEATURES
• Waterproof polypropylene suitcase;
• Dimensions: 20 X 34 X 41 cm;
• 36 V - 15 Ah lithium-ion baery - Dimensions 76 X 70 X 260 mm;
• Li-Ion baery charger;
• Universal input Voltage 110/230 Vac, 50/60 Hz;
• Weight 11 Kg;
• Baery life more than 7000 meters;
• Speed controller;
• Torque controller;

2.ADAPTER
ASSEMBLY
Take adapters;
Insert adapters on your
Jeng machine one by
one
Put electric motor
into the adapters
Take your LADY
jeng machine
Result should be as
shown in picture above
Now you can start
to jet cables
A
C
E
B
D
F
A
C
E
B
D
F

3.PANEL
CONTROL
1 2
3
6789
45
1. Baery Charge Level;
2. Motor Electrical Consumpon;
3. Torque Alarm (Red Light = Torque Limiter);
4. Torque Reset Buon;
5. Torque Control Knob;
6. Protecon Fuse;
7. Charging Port;
8. Main Switch;
9. Current Alarm (Red Light = Current Limiter);
10. Emergency Key;
11. Speed Controller Knob;

11
10
4.MOTOR
DIRECT
CONTROL
EMERGENCY KEY
Pressing this buon
you can stop motor
operaons in any moment.
(To Restore just turn it following
arrows direcon)
Using this knob you
can control motor speed
to ensure maximum eciency
SPEED CONTROLLER

5.Li-Ion
BATTERY
CHARGER
• Advanced High Frequency switching mode
power supply technology;
• DC output isolated from AC input;
• Single Input 110 Vac and 230 Vac or Universal
Input 110/230 Vac, 50 Hz ~ 60 Hz;
• Charging parameters are insensive to the AC
input line voltage variaons;
• Completely automac baery charging: CC, CV;
FEATURES
• 2 LEDs: LED 1 Red = Power on, LED 2
Red/Green = Charging/Charged;
• Short circuit, over voltage, over-tempera-
ture, reverse polarity protecons;
• Eciency > 85 %;
• Forced venlaon with fans;
• 100% full load burn-in test;

6.HOW TO
LAY CABLES
A. Set speed controller (11) into posion “0”;
B. Set Main Switch (8) on “I” posion ;
C. Adjust the torque using “speed controller knob”(11), according to cable
outer diameter (Small cable = Low Torque / Large cable = High Torque);
IN CASE OF
D. Torque Alarm (3) turns into red light set the speed controller (11) to “0” -
Press Torque Reset Buon (4) and readjust torque using its control knob
(11)- (Restart from C);
E. Current Limiter (9) turns into red light set the speed controller to “0” and
switch OFF using Main Switch (8) then switch ON and restart from C;
WARNING FIBERNET srl is not responsible for damages to people or things caused by incorrect use of this machine.

Via degli Olmetti, 18 - 00060 Formello (RM) – Rome, ITALY
Tel. [phone] - Fax [phone]