Fired Up Corporation Spacer User manual

FUI0067 V1_150120
SPACER INSTALLATION GUIDE
www.firedupcorporation.com/manual
Electric Inset Fire - Spacer
Installation Guide
Please read through the use & care manual provided with this product first.

0 2
INSTALLATION
PARTS PROVIDED
• Spacer (Assembled inc Brackets)
• Screw Driver
• Spanner
• 6x Self Tapping Screws
• 4x Hex Head Bolts
Installation
Ensure two brackets are fastened loosely, not tight. If tight, loosen with spanner provided.
Brackets
Spanner
Attach inset fire to spacer, using self
tapping screws provided, & screw driver.
Postion the bottom of the trim behind the
locating brackets on the fire, push the trim
forward at the top, and then drop down,
ensuring the fire locates within the corners
of the trim.Then push down.
1.
2. 3.
1. 2.
Rear View of Fire

0 3
INSTALLATION
From the rear, adjust the trim and close any gaps,
then tighten all 4 bolts.
4.
5.
Screw ends will be present on the rear of the fire,
beware of sharp edge .
SHARP EDGES -
WATCH HANDS & FINGERS
CAUTION