First Office THE EDGE User manual

THE EDGE
Canopy
ASSEMBLY INSTRUCTIONS

INSTRUCTIONS
Idea Lounger
Support Rail
#8 x 2"
Pan Head
Composite
Deck Screw
Slat
DRILL
#8 x 1-1/2"
Pan Head Screw
TOOLS REQUIRED:
Rev:
Dwg:
THE EDGE by FIRST OFFICE | 2
Canopy
ASSEMBLY INSTRUCTIONS

INSTRUCTIONS
Step 1: Assemble Canopy
Begin by placing the three "L" shape support rails in a line as shown above. •
Making sure the pre-drilled holes are aligned, attach seven slats to the •
ceiling surface of the support rails using the supplied 2" deck screws as
shown in the view above.
Rev:
Dwg:
INSTRUCTIONS
Step 2: Attach Canopy to Lounger
Locate the seven pre-drills on the side of the lounger end panel. •
Place the canopy up against the lounger and visually check to make sure •
all the seven mounting holes line up with one another. Once the lounger
and canopy are aligned, attach canopy to the lounger using the supplied
1-1/2" wood screws.
Rev:
Dwg:
Assemble Canopy
1. Begin by placing the three “L” shape support rails in a
line as shown.
2. Making sure the pre-drilled holes are aligned, attach
seven slats to the ceiling surface of the support rails
using the supplied 2" deck screws as shown.
THE EDGE by FIRST OFFICE | 3
Canopy
ASSEMBLY INSTRUCTIONS
Attach Canopy to Lounger
1. Locate the seven pre-drills on the side of the lounger
end panel.
2. Place the canopy up against the lounger and visually
check to make sure all seven mounting holes line up
with one another. Once the lounger and canopy are
aligned, attach the canopy to the lounger using the
supplied 1-1/2" wood screws.

INSTRUCTIONS
Step 3: Attach Remaining Slats
Making sure the pre-drilled holes are aligned, attach all remaining slats to •
the vertical surface of the support rails using the supplied 2" deck screws as
shown in the view above.
When the assembled unit is placed in its final position, verify that all fasteners •
are tight and unit is level. Assembly is now complete.
Rev:
Dwg:
Attach Remaining Slats
1. Making sure the pre-drilled holes are aligned, attach all
remaining slats to the vertical surface of the support
rails using the supplied 2" deck screws as show.
2. When the assembled unit is placed in its final position,
verify that all fasteners are tight and unit is level.
THE EDGE by FIRST OFFICE | 4
Canopy
ASSEMBLY INSTRUCTIONS