First K9 User manual

1x
1x
Attach one LEGO® hard point connector to the 166 mm C
channel.

1x
2x
Connect the LEGO® 9 hole straight beam to the hard point connecter with
the two pegs.

1x
Bolt the servo mount to the 166 mm C
channel.

Assemble the baring package by connecting it
to the servo mount.
1x

Bolt a servo on to the
servo mount.
1x

2x
Attach two 288mm C channels
to the 166mm C channel.

1x
A second 166mm
C channel is
added to the
288mm C
channels.

The motor mounts
are connected to
the bottom of the
288mm C channels.
2x

1x
Bolt the 144mm L bracket to the
244mm C channels in front of the
motor mounts. This will be used
later to mount the 12V battery.

2x
Attach the two 32mm C channels
to the two 244mm C channels on
the opposite side as the motor
mounts. These will later be used
to mount the axel assemblies.

1x
Attach a 166mm C channel
to the two 288mm C
channels.

1x
Attach another 166mm C
channel to the 288mm C
channels.

Use the two rounded L brackets when
attaching the plate to the 166mm C
channels.
2x
1x

Repeat last step to the other side of the
robot.
1x
2x

1x
Tighten a motor into motor mount so that the motor shaft
is towards the top of the robot. (Robot is upside down in
pictures.)

Attach the motor cable
and secure it with a zip
tie.
1x

Repeat the last two steps to the other
side of the robot.
1x
1x

Read directions with
encoders if you would
like to install encoders
onto your robot.
2x
OPTIONAL:

Mount the servo
horn to the pivot
bracket.
1x 1x