Dance Function
Loading Frisbee Frisbee Sending Function
Battery Installation
According to the illustration to open the head
upside, put the frisbees into it, close the head.
Please only used the frisbees that are included
in the product. In the instances that the frisbees
are not properly loaded, it can't sending. Please
remove the frisbees and reload it again.
1) Install the frisbees well. 2) You must press
the“ ” button, the robot will say: "Laser on".
3) Press the “ ” button to send the frisbees.
Caution: Do operate it in orders, otherwise can't
send the frisbees. During sending the frisbees
you can send the frisbees continuously, you can
press the“ ” “ ”button to adjust the angle and
prolong time of sending frisbee.
1.The robot takes four AA 1.5V batteries.
(not included)
Robot battery installation:
a.Using a screwdriver loosen the screw on the
battery compartment.
b.Insert four AA 1.5V batteries making sure you
follow the designated “+”,“- ” signs.
c.Close the battery compartment.
Warning
1.Please do not try and recharge batteries, always
replace them.
2.Incorrect use of batteries may cause damage, so
please pay attention to the following:
(a)Do not install batteries with opposite polarity.
(b)When not in use, please switch to OFF position
and if the robot is not going to be used for a long
time, please remove batteries to avoid corrosion.
(c)Do not mix old and new batteries.
(d)Please replace exhausted batteries as soon as
possible.
(e)Keep batteries away from children.
( f)Do not place batteries near fires or expose them to
strong sunlight or damp conditions.
(g)Please dispose of batteries carefully.
3. Please don’t use it in the strong sun. Don't shoot at the
people when you send frisbees.
4. Do not eat small parts taken down.
5. Do not place it near fire, high temperature or damp
condition.
6. For not to pollute the environment, please don’t throw
package away casually.
Remote control battery installation:
a.Using a screwdriver loosen the screw on the
battery compartment.
b.Insert two AA 1.5V batteries making sure you
follow the designated “+”,“- ” signs.
c.Close the battery compartment.
2.The remote control takes two AA 1.5V
batteries.(not included)
56
Press the “ ” button of the controller, the robot
will show a beautiful dance !
7
8
8
Important:Please Do Not aim discs at persons or animals when firing.
Press the “ ”，“ ” button of the controller,
the robot will turn to the left and to the right
correspondingly.
5
5
6
6
Turn Function
ONOFF
