Fish On Sports Sportsman Uni-Arch Manual

Sportsman Uni-Arch Directions
Parts List
(13) 1/4 x 3” Bolts
(13) 1/4-20 Nuts (4) Backing Plates (8) O-Rings
Optional Parts
Additional Rod Holders
Radar Pad
Light Brackets
Special Notes
If you are going to run wires in your arch, it
is best to do as you assemble it.
Position of holes to wire are up to the
customer.
If you need to swap mounts “ deck or side”
send yours back along with $25 for
shipping and we will exchange.
Hand tighten all stainless hardware. If
you use power tools the bolts will lock
up. Use a lube on the top Center Bolts.
(2) Arch Sides
(2) Corner Braces (2) Rear Leg Ext
(4) Elbows
(4) Mounts
(1) Center
Note: If you ordered a radar pad
Loctite Bolts that your are not going to
loosen.

Assembly
Step 3
Insert Elbows into arch tops and
reinsert bolts with locktite.
Do not tighten bolts all the way
at this point
Make sure to have the elbows
going to the right on one arch side
and to the left on the other.
It does not matter what elbows
go with which arch side.
Step 2
Place 2 O-Rings on each elbow,
approx 2” and 8” from the end.
Slide the 2 arch sides into the center section. “Evenly”
Step 1
This is the point where you
should get your approx width close.
Wait to drill holes and install bolts,
until the arch is mounted on the boat.
Step 5
Install the brake away brackets and reinsert bolts.
Step 6
Instal the 2 corner braces. Do not
tighten these all he way up, until the
arch is fastened to the boat. You will
want to Loctite these bolts when
done with the instal
You will want to loctite these bolts when
you are done with the instal to you boat.
Step 4
Install the Rear Leg
extension. You will want
to loctite these bolts
when you are done with
the install.

Installation
Step 1
Position the arch
where you would like to mount it.
Have a friend holdit in place if possible.
Then drill holes.
Step 2
Install backing plates if possible and tighten bolts.
Note: The mounting bolts are the only hardware that
we do not supply.
Step 3
Now is the time to go through
loctite and tighten the 24 elbow
Step 4
Make sure your center section is still centered.
Then drill out the pre drilled holes and install the
(8) 1/4-20 x 3” nuts and bolts.
You can also install the radar pad at this time in
the pre drill holes
Step 5
The arch is now fixed and you can mount
the rod holders, and or light brackets.
These clamp on items are friction lock.
So start all bolts and tighten evenly.
If your need to rotate your rod holder do so
before mounting them.
If your mount does not sit flat on the boat we
do sell a wedge kit, that will give you a 1/4” of
rake from one side to the other
bolts You will want to use a
lubrication for these
bolts and spin them
slowly.
If you are going to move your rod holders
and are in Saltwater, you will need to use
a protective agent on the bolts,
Do the same for your corner braces
If you have any questions or by chance are missing any
components. Please give us a call. 1888 675 6850.
Thank you very much for ordering our radar arch.

Free T-Shirt or Hat
Email us a picture of your installed Fish On Structure,
and we will send you a free T Shirt, or Hat
[email protected]