Fisher & Paykel DD24DAX9 Operating instructions

Troubleshooting
Excessive water remaining above the filter plate, after the rinse cycle. (This is displayed as
an
fault)
• Check for a kinked drain hose, blocked waste connection, highloop not properly installed, drain hose not routed
correctly or spray arms not in place.
No water supply. (This is displayed as an
fault )
• Check water is connected and turned on.
The dishwasher is beeping continuously
• There is a fault. See section ‘If there is a fault’ in the User guide for further information and instructions.
No program indicator lights up when the drawer is opened
• Ensure power is connected and is switched on. If it is and still no indicator lights up, see the ‘Preference options’
section of the ‘Quick start guide’. An option called ‘Open drawer auto power-on’ may need to be turned on.
Water around water supply and drainage connections
• Check connections, existing plumbing and hoses for leaks. Check rubber washer and hose clamp are correctly
fitted.
If product is tipping
• Ensure the product is secured to the cabinetry.
https://producthelp.fisherpaykel.com/us/Clean/DishDrawer%E2%84%A2/Double/DD24DAX9/Installation_Guide_DD24DAX9/1…
Updated: Tue, 16 Nov 2021 11:53:15 GMT
Powered by
1

If front panels are Misaligned
• Check and re-level product. Check the cabinetry is square. For Integrated models, check and adjust front panel
alignment if necessary.
Drawer doesn’t close properly
• Ensure nothing is obstructing the drawer from closing properly eg hoses or drawer latches.
• If a problem occurs, consult the ‘Troubleshooting’ section of the User guide.
• If after checking these points you still need assistance, please refer to the Service & Warranty book for warranty
details and your nearest Authorized Service Center, or contact us through our website, listed below.
https://producthelp.fisherpaykel.com/us/Clean/DishDrawer%E2%84%A2/Double/DD24DAX9/Installation_Guide_DD24DAX9/1…
Updated: Tue, 16 Nov 2021 11:53:15 GMT
Powered by
2