Fisher & Paykel DW60U2I1 User manual

Fault Codes
If the dishwasher malfunctions, it will display a fault code and beep. Check the following table below to see if you can
correct the fault yourself.
If the dishwasher still will not work, or shows any other fault code
1. Press and hold to turn the dishwasher off and wait a few minutes.
2. Open door to turn the dishwasher back on.
If the dishwasher still does not function and/or the problem persists, disconnect the dishwasher from the power supply,
turn the water supply off, then contact Fisher & Paykel Customer Care with the fault code information.
Fault Code &
Descriptions Possible Causes What to Do
Drain hose is crimped or bent. Check the drain hose and straighten if needed.
The waste water is not draining
out.
Ensure that the drain hose is connected in accordance
with the installation instructions.
The turbidity sensor is dirty and
requires cleaning. Gently clean the turbidity sensor with a soft brush (ie
toothbrush) to remove any buildup.
https://producthelp.fisherpaykel.com/au/Clean/Dishwashers/DW60U2I1/User_Guide_DW60U2I1/16_Fault_Codes
Updated: Sat, 16 May 2020 01:06:11 GMT
Powered by
1

Fault Code &
Descriptions Possible Causes What to Do
Water tap not turned on.
Ensure the water is connected and turned on.
Press
to restart the dishwasher.
Insufficient water supply
pressure. Check household water pressure.
Water inlet hose is crimped or
bent, so no or not enough water
gets to the dishwasher.
Check the water inlet hose and
straighten if needed. Press
to restart the
dishwasher.
Drain hose is not connected
correctly.
Ensure that the drain hose is connected in accordance
with the installation instructions.
Flood switch activated.
Turn the dishwasher OFF and ON again. If fault persists,
turn water off and disconnect the dishwasher from the
power supply. Call Customer Care.
Water flow error. Switch dishwasher OFF and ON again. If fault persists call
Customer Care.
Electronics error. Switch dishwasher OFF and ON again. If the
fault persists call Customer Care.
https://producthelp.fisherpaykel.com/au/Clean/Dishwashers/DW60U2I1/User_Guide_DW60U2I1/16_Fault_Codes
Updated: Sat, 16 May 2020 01:06:11 GMT
Powered by
2

Fault Code &
Descriptions Possible Causes What to Do
Water temperature error. Switch dishwasher OFF and ON again. If fault
persists call Customer Care.
(DW60U6I Only)
Data/electronics error. Switch dishwasher OFF and ON again. If fault
persists call Customer Care.
Electronics/power supply error. Switch dishwasher OFF and ON again. If fault persists call
Customer Care.
(DW60U6I Only)
Doorlock signal error. Switch dishwasher OFF and ON again. If fault
persists call Customer Care.
(DW60U6I Only)
Motor fault.
Switch dishwasher OFF at the power supply.
Wait a few moments and switch ON again.
If the fault persists, turn water off and disconnect from the
power supply. Call Customer Care.
https://producthelp.fisherpaykel.com/au/Clean/Dishwashers/DW60U2I1/User_Guide_DW60U2I1/16_Fault_Codes
Updated: Sat, 16 May 2020 01:06:11 GMT
Powered by
3