Fisher-Price BML40 User manual

1
fisher-price.com
BML40
Please keep this instruction sheet for future reference,
as it contains important information.
Requires four AA batteries (included).
Batteries included are for demonstration purposes only.
Adult assembly required for battery replacement and crib attachment.
Tool required for battery replacement: Phillips screwdriver (not included)
Wipe this toy with a clean, damp cloth. Do not immerse.
This toy has no consumer serviceable parts. Do not take apart.

2
©2015 Mattel. All Rights Reserved.
PRINTED IN CHINA BML40a-0921
Consumer Information
CO
N
SU
MER
ASS
I
S
T
A
N
CE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.This
equipment generates uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications.However, there is no
guarantee that interference will not occur
in a particular installation.If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
NOTE: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept
any interference, including interference that
may cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes : (1) il ne
doit pas produire de brouillage et (2) il doit
pouvoir tolérer tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible de
compromettre son fonctionnement.

3
Consumer Information
IMPORTANT! Always attach with all provided fasteners tightly to a crib or playpen according to
the instructions. Do not add additional strings or straps to attach to a crib. Check frequently.
WARNING
Prevent Entanglement Injury
• This product may not attach to all crib designs. Do not add
additional strings or straps to attach to a crib or playpen. Use only
the crib connector.
• Use crib connector ONLY attached to a crib or playpen.

4
1,5V x 4
AA (LR6)
Battery Replacement
• Slide the soother out of the crib connector. Locate the battery compartment door on the back of
the soother.
• Loosen the screw in the battery compartment door with a Phillips screwdriver and remove the
door. Remove the exhausted batteries and dispose properly.
• Insert four, new AA (LR6) alkaline batteries.
• Replace the battery compartment door and tighten the screw. Do not over-tighten.
• If this product begins to operate erratically, you may need to reset the electronics. Slide the
power/volume switch off and back on.
• When sounds/light become faint or stop, it’s time for an adult to change the batteries.
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury
or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted batteries from the
product. Dispose of batteries safely. Do not dispose of product in a fire. The batteries inside may
explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged under adult supervision.
Battery Safety Information
• Protect the environment by not disposing of this product with household waste
(2002/96/EC). Check your local authority for recycling advice and facilities.
For longer life, use alkaline batteries.

5
Crib Attachment
C
C
C
r
r
r
i
i
i
b
b
b
A
A
A
t
t
t
t
t
t
a
a
a
c
c
c
h
h
h
m
m
m
e
e
e
n
n
n
t
t
t
• Slide the soother into the crib connector.
• Position the crib connector inside the crib. Make sure the attachment strap is on the outside
of the crib A.
• Slide the end of the attachment strap down through the slot on the back of the crib
connector B. Pull the end of the attachment strap up and fasten to the peg on the back
of the crib connector C.
Note: This crib connector should be snug against the crib rail and spindles. Use the strap slot that
provides the tightest fit.
• If you have excess strap, slide the free end of the attachment strap through the opening near the
top of the attachment strap D.
A
C
D
B
1
• Tie the strings to a crib spindle.
Note: It is better to tie the strings in a knot than a bow, since a bow may be easily untied.
2

6
• If the distance between the crib connector and the mattress is less than 7 inches (18 cm), lower
the crib mattress.
Mattress
Mattress
At Least
At Least
7 Inches (18 cm)
7 Inches (18 cm)
Bottom of
Bottom of
Crib Connector
Crib Connector
Crib Attachment
3

7
Before First Time Use
Slide the power/volume switch to:
ON with high volume
ON with low volume
OFF
Slide the mode switch to:
Music Only
Music & Lights
Lights Only
Slide the mode switch
to to turn off try-me
demonstration mode.
Slide the soother out of the
crib connector.

8
• Slide the soother back inside the crib connector.
• Press the button to start music/lights. Press the button again to change the music. Press and
hold the button to turn off music/lights.
Notes:
• This product times out after approximately 10 minutes in lights only mode; 30 minutes in music
only mode; and in music & lights mode the lights will fade after approximately 10 minutes of use
and the music will continue to play for approximately 30 minutes.
• Press the button again to restart.
Dresser Top & On-the-Go Use
• Slide the soother out of the crib connector for dresser top or on-the-go use.
Soothing Music & Projection
PRESS
PRESS