Flash Furniture QT-KTL-4023GY-GG User manual

Thank you for your purchase!
Customer Service Email: [email protected] | Phone: [phone]
QT-KTL-4023BK-GG/ QT-KTL-4023BRN-GG/ QT-KTL-4023GY-GG
ASSEMBLY INSTRUCTIONS
Before You Begin:
Please read the instructions carefully before assembly and use.
Be sure to follow the steps when installing, otherwise the plastic panel will be difficult to remove.
Rattan Style
Outdoor Storage Box
Warning:
CHOKING HAZARD - Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware (where
included) to help prevent the unit from tipping and causing accidental injury, instability, death or damage. The
tipping restraint is intended only as a safety measure, it is not a substitute for proper adult supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall Straps
suitable for the unit weight and wall materials (if not included) should be purchased and installed.
Online Assembly Instructions: http://ftp.flashfurniture.com/AssemblyInstructions/QT-KTL-4023GY-GG.pdf

• Please keep away from sources of extreme heat and naked flame.
• Please read through these instructions before beginning assembly.
• Two adults should be present for assembly.
• Clear the space for assembly and lay out all parts based on the Parts List. Ensure that all pieces are present.
• Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts
or hardware.
• Keep small parts and pieces away from children.
• Use on even surfaces only.
• Improper use of this product or failure to use as directed may result in injury.
• Do not stand on the storage box.
Caution:
Although the product material is waterproof, there may be gaps due to assembly. Do not store objects
that may be damaged by moisture.
SAFETY PRECAUTIONS:
Warning:
The warnings, precautions, and instructions discussed in this instruction manual cannot cover all
possible conditions and situations that may occur. It must be understood by the purchaser that safe
practices and caution must be used. Read carefully and understand all instructions before operating.
Failure to follow the safety rules and other basic safety precautions may result in serious personal
injury.

PARTS
STEP 1
Insert the tabs on the front & back panels into the right and left side panels and snap into place
STEP 2
Insert the tabs on the bottom of the assembled front, back and side panels into the bottom and snap into
place.
STEP 3
Attach the lid to back panel using four hooks.
Attach the four hooks (Part 1) to the lid (Part F) first by clicking into
the holes then snap into the holes in the back panel (Part B).
Front Panel (Part A)
Back Panel (Part B)
Right Side Panel (Part C)
Left Side Panel (Part D)
Part A
Part B
Parts C & D
Part E
Part E
Part FPart 1
Part F
Part 1