Flexdesk Z Series User manual





ThankyouforpurchasingaFLEXDESKZ‐SERIES.TheFLEXDESKproductlineisdesignedtoenhanceyour
workspace.Pleasefollowallassemblyinstructionscorrectlytoprovideoptimaluse.
OnlyaqualifiedcontractorshouldinstalltheFLEXDESKZ‐SERIES.Ifyoudonotunderstandanyofthe
assemblyinstructions,pleasecontactyourlocalre‐sellerorvisitwww.joromfg.com.
IMPROPERINSTALLATIONCANCAUSEDAMAGETOYOUREQUIPMENTANDMAYLEADTOSERIOUS
PHYSICALINJURY.JOROManufacturingcannottakeanyresponsibilityfordamageorinjuryresulting
fromimproperinstallation.
DonotoperateZ‐SERIESframeifthereareanyimmediateobstructionsbelowor
abovetheworkstation.Doingsomaycauseunitmalfunctionorleadtoserious
physicalinjury.
ThesuppliedmountinghardwareisforuseontheFLEXDESKZ‐SERIESonly.Ifyouencounterany
problemsorinsufficienthardwareduringinstallation,pleasecontactyourlocalre‐seller.

#12 x 3/4" Pan Head Wood Screw
x12
x1
5mm Allen (Hex) Key
x1
Power Cable - 2m
x4
3in Swivel Glide
Nylon Cable Clip 1/4''
x10
M6 x 8mm Socket Cap Screw
x8
Z-Series Work Surface Kit
(ONLY when applicable)
(ONLY when applicable)
Note: Parts may not be exactly as shown and not to scale
Z-Series Modesty Kit
Z-Series Main Frame Kit
x1
Up/Dwon Switch x1
Smart Control Box
#8 x 3/4" Pan Head Wood Screw
x14
x2
Motor Cables - 1m
x4
TUBE1020 End Cap
Z-Series ASSY Instructions : 0.001

TUBE1020 End Cap
M6 x 8mm Socket Cap Screw
Be sure to use
M6 x 8mm Socket Cap Screw
Start all M6 x 8mm Socket Cap Screw
prior to tightening, then tighten all screws
Z-Series ASSY Instructions : 0.001
DETAIL F
SCALE 1 : 6
3in Swivel Glide
Fasten modesty (when applicable)
Be sure to NOT over tighten
Position TUBE1020 End Cap
(when Applicable) and push into place
Fasten the 3in Swivel Glides
Be sure to NOT over tighten
1
2
3

#8 x 3/4" Pan Head Wood Screw
Be sure to use the #8 x 3/4" Pan Head Wood Screw
provided (when applicable)
Be sure to use the #12 x 3/4" Pan Head Wood Screw
provided (when applicable)
#8 x 3/4" Pan Head Wood Screw
Fasten the work surface (when applicable)
Be sure to NOT over tighten
Fasten the control box and switch
Be sure to NOT over tighten
#12 x 3/4" Pan Head Wood Screw
Z-Series ASSY Instructions : 0.001
4
5

Nylon Cable Clip 1/4''
Plug in cables
Wire management
Z-Series ASSY Instructions : 0.001
#8 x 3/4" Pan Head Wood Screw
Be sure to use the Nylon Cable Clips and
#8 x 3/4" Pan Head Wood Screw provided
(when applicable)
Be sure to NOT over tighten
6
7



8