Fluval Aquasky 14550 User manual

INSTRUCTION MANUAL
SKY
APP CONTROL LED
FOR FRESH OR SALTWATER AQUARIUMS
Aquasky operates exclusively via your
smart phone or tablet (not included).

IMPORTANT SAFETY INSTRUCTIONS
WARNING – To guard against injury, basic safety precautions should be observed,
including the following:
1.
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
and all the important notices on the appliance before using. Failure to do so may
result in loss of fish life and/or damage to this appliance.
2. DANGER – To avoid possible electric shock, special care should be taken since
water is employed in the use of aquarium equipment. For each of the following
situations, do not attempt repairs yourself; return the appliance to an authorized
service facility for service or discard the appliance.
A. If the appliance shows any sign of abnormal water leakage, immediately
unplug it from the power source.
B. Carefully examine the appliance after installation. It should not be plugged in
if there is water on parts not intended to be wet. If the appliance or any part
of it falls into the water DO NOT reach for it.First unplug the unit before
retrieving.
C. Do not operate any appliance if it has a damaged cord or plug, or if it is
malfunctioning or it is dropped or damaged in any manner. The power cord of
this appliance cannot be replaced; if the cord is damaged, the appliance
should be discarded. Never cut the cord.
D. To avoid the possibility of the
appliance plug or receptacle getting
wet, position the appliance to one
side of a wall mounted receptacle to
prevent water from dripping onto the
receptacle or plug. A “drip loop” (see
illustration) should be arranged by the
user for the cord connecting appliance
to a receptacle. “The drip loop” is
that part of the cord below the level
of the receptacle or the connector if
an extension cord is used, to prevent
water from travelling along the cord and coming in contact with the receptacle.
If the plug or receptacle does get wet, DO NOT unplug the cord. Disconnect the
fuse or circuit breaker that supplies power to the appliance. Then unplug and
examine for presence of water in receptacle.
3. This appliance is not intended for use by persons (including children) with
significantly impaired physical or mental capabilities, unless they have been
given supervision or instruction concerning the use of the appliance by a person
responsible for their safety. Children should always be supervised to ensure that
they do not play with the appliance.
4. To avoid injury, do not touch moving parts or hot parts.
5. CAUTION - Always unplug or disconnect all appliances in the aquarium from
electricity supply before placing hands in water, before putting on or taking off
parts and while the equipment is being installed, maintained or handled. Never
yank cord to pull plug from outlet. Grasp the plug and pull to disconnect. Always
unplug an appliance from an outlet when not in use.
6. Do not install or store the appliance where it will be exposed to weather or
temperatures below freezing. FOR INDOOR HOUSEHOLD USE ONLY. DO NOT
IMMERSE.
7. Make sure the appliance is mounted correctly and securely positioned on the
aquarium before operating the appliance.
8. If an extension cord is necessary, a cord with proper rating should be used. A
cord rated for less amperes or watts than the appliance rating may overheat.
Care should be taken to arrange the cord so that it will not be tripped over or
pulled. The connection should be carried out by a qualified electrical installer.
9. Use only with AC adapter supplied with this product.
10. The socket-outlet shall be installed near the equipment and shall be easily
accessible.
11. LED power supply shall not be positioned on or into the cover frame.
12. “Z” attachments: The external flexible cable or cord of this luminaire cannot be
replaced; if cord is damaged the luminaire shall be destroyed.
13. This luminaire can be mounted on any aquarium with glass thickness of between
3mm and 15mm.
SAVE THESE INSTRUCTIONS
For the complete use and understanding of this product it is recommended that
this manual is thoroughly read and understood. Failure to do so may result in
damage to this product.
The Fluval Aquasky Bluetooth
®
LED combines super bright 3000-25000 K LEDs with tri-color RGB LEDs to allow the
user to adjust, via Bluetooth
®
enabled smart device, the light spectrum in order to replicate various environments; and
create such effects as cloud cover, fading lunar, storm and lightning.

INSTALLATION AND USAGE:
Please verify that all components of the light fixture are undamaged before putting it into operation.
Before any kind of maintenance, always disconnect electrical supply of the light fixture.
• Make sure the light fixture is mounted correctly and securely positioned on the aquarium
before operating the appliance.
• On a plain glass aquarium always ensure that the brackets are on the outside of the aquarium
frame. If needed, the extendable mounting brackets can be adjusted accordingly to ensure
proper fit on aquarium.
• Connect the plug from the transformer to the plug on the fixture.
• Connect the transformer to electrical supply.
MOUNTING BRACKET INSTRUCTIONS
This is a mounting system only and does not provide power to the LED strip.
REMOVING THE EXISTING LIGHT TUBE
• Disconnect the T8/T5 lighting system from the power supply and do not reconnect.
• Please ensure that the LED strips are not connected to the power supply when
mounting into the T8/T5 lighting system using the mounting brackets.
• Unscrew both end caps and move them into the center of the tube.
• Remove the tube by sliding it gently out of the fitting.
INSTALLING THE MOUNTING BRACKETS
• Clip the mounting brackets over the ends of the
extending arms of the LED strip, as per the photo
(A). You may need to pull out the
extending arms slightly to do this.
• For T5 lighting systems: fit the
end caps over the end of the mounting
brackets, to face inwards.
• For T8 lighting systems: click to fit the T8
ring adapter onto the end of each
mounting bracket, then follow the instructions
above for T5 lighting systems.
• Fully tighten the end caps back onto the threads,
being careful not to cross thread or over tighten.
You may need to extend or retract the extending
arms to make the LED strip fit perfectly (B).
• WARNING: Before connecting the power supply,
ensure that the LED strip is securely fastened to
lighting system of the aquarium so that it is
stable and cannot fall into the water. The
LEDs are tested to IPX7, which means they
can withstand temporary
submersion. NOTE: THIS IS NOT A SUBMERSIBLE LIGHT
• Connect the power supply to the LED strip and switch on.
INSTALLING THE CEILING BRACKET
• Clip the ceiling brackets over the back (side with
fins) of the LED strip.
• Use suitable fixings for the intended mounting
surface. If you wish to bond the brackets to glass
or plastic use aquarium silicone.
• WARNING: Do not screw the bracket onto any
housing containing electrical wiring or
connections, such as lighting ballasts,
due to severe risk of electric shock.
A
B
SCAN HERE to learn more
and download the free Fluval Smart app
or search ‘Fluvalsmart’ in app store.
For full instruction manual and video on set up of Bluetooth® application, visit:
fluvalaquatics.com/aquaskybluetooth
FULLY CONTROLLABLE
FROM YOUR SMART PHONE
OR TABLET

MAINTENANCE:
For maximum LED performance, it is recommended that the fixture and the LED lens be
cleaned on a weekly basis. Unplug transformer prior to cleaning the light fixture and remove
from aquarium. Use both hands when manipulating this appliance. Wipe exposed surfaces
carefully with a damp cloth to remove any dust or mineral deposits that may collect over
time. Do not use detergents or harsh cleaners as it can damage the light fixture. Use Fluval
LED Lens Cleaning Non-Aerosol Spray (A3969) to clean the LED portion of the light fixture.
Make sure all surfaces are dry before re-connecting the transformer to the power source.
BASIC TROUBLE SHOOTING
If the fixture does not work, ensure that all plugs and wires are firmly connected, ie: connection
from fixture to transformer, and connection from transformer to electrical outlet.
Model: 14550 14551 14552 14553 14554 14555 14556
Input Volts: 90-250 V 90-250 V 90-250 V 90-250 V 90-250 V 90-250 V 90-250 V
Operating
Volts: 24 V 24 V 24 V 24 V 24 V 24 V 24 V
Size
Adjustment: 38-61cm 53-83cm 75-105cm 83.5-106.5cm 91-122cm 99-130cm 115-145cm
No. of LEDs: White (24)
RGB (12)
White (28)
RGB (14)
White (42)
RGB (21)
White (42)
RGB (21)
White (42)
RGB (21)
White (48)
RGB (24)
White (56)
RGB (28)
Wattage: 12 16 21 25 27 30 33
Lumens: 800 1100 1450 1850 1850 1950 2260
Life in Hours 50 000 50 000 50 000 50 000 50 000 50 000 50 000
WARRANTY
3 YEAR LIMITED WARRANTY
Your Fluval Aquasky Bluetooth®LED Strip Light is guaranteed for defective parts and workmanship
for a period of three years from the date of purchase. This guarantee is valid with proof of purchase
only. The guarantee is limited to repair or replacement only and does not cover consequential loss,
loss or damage to livestock and personal property or damage to animate or inanimate objects,
irrespective of the cause thereof. This guarantee is valid only under normal operating conditions
for which the unit is intended. It excludes any damage caused by unreasonable use, negligence,
improper installation, tampering, abuse or commercial use. The warranty does not cover wear
and tear or parts which have not been adequately or correctly maintained. Failure of less than
5% of the total number of LEDs shall not be considered a defect under the terms of this warranty.
THIS DOES NOT AFFECT YOUR STATUTORY RIGHTS
.
FOR AUTHORIZED WARRANTY REPAIR SERVICE:
For Authorized Warranty Service please return (well packaged and by registered post) to the
address below enclosing dated receipt and reason for return. If you have any queries or comments
about the operation of this product, please let us try to help you before you return the product to
your retailer. Most queries can be handled promptly with a phone call. When you call (or write),
please have all relevant information such as model number, age of product, details of aquarium
set-up, as well as the nature of the problem.
UK: Rolf C. Hagen (UK) Ltd
, Customer Service Department California Drive, Whitwood Ind Est., Castleford West
Yorkshire WF10 5QH http://faq.hagencrm.com/?uk
CALL US ON (U.K. ONLY):
Helpline Number 01977 521015. Between 9:00 AM and 5:00 PM, Monday to Thursday and
9:00 AM and 4:00 PM on Friday (excluding Bank Holidays).
RECYCLING:
This symbol bears the selective sorting symbol for waste electrical and electronic equipment
(WEEE). This means that this product must be handled pursuant to European Directive 2012/19/EU in order
to be recycled or dismantled to minimize its impact on the environment. Check with your local Environmental
Agency for possible disposal instructions or take to an official council registered refuse collection point.
Electronic products not included in the selective sorting process are potentially dangerous for the
environment and human health due to the presence of hazardous substances.
This manual suits for next models
6
Table of contents
Other Fluval Lighting Equipment manuals