FLYDOR Unika MUV User manual

t: 01603 897 799 e: [e-mail]
Unika Window Screen
Fittin Instructions
www.flydor.co.uk

Step 1 Before proceeding, decide which of fitting options you wish to use and
prepare the side guides prior to assembling the unit.
Unika Window Screens (All MUV models)
FACE FITTING Option A Drill a .5 mm hole through
the outer groove, ensuring you remain witin the
recessed area in pic 2.
(Tip) Use a 2mm bit for the pilot hole into the frame.
Please note you will need a hex bit for the screws
FACE FITTING Option B Drill directly through the
guide using a mm bit., ensuring you remain witin
the recessed area as in pic 2. Open the front facing
hole to 7mm and use the cover caps provided for a
neat finish.
(Tip) Use a small screw ( .5x 16) to affix to frame.
RECESS FITTING Option C Drill .5 mm holes
through the sides of guides, for directly fixing into
the recess. Typically two or three depending on
height.
(Tip) Use the special tool 8460.0 to allow the fluffy
pile to be safely moved when fitting.
Step 2 Fitting the Concealed Catches to the side guides.
To avoid the fluffy pile being pulled back into the
cassette during use. Trim about 6mm off the length
of the pile. Simply crimp the channel top and
bottom with a flat headed screwdriver and hammer.
(Tip) Gently does it! Avoid bending the guide out of
shape by hitting too hard.
Slide the catches (marked L or R) into the
appropriate guide as shown. Ensure the hook is to
the (grooved) front .Crimp the guide to hold the
catch firmly in place. This prevents catches being
forced out in operation.
(guides are shown with no pile for illustration
purposes)
OPTIONAL INTERMEDIATE STOPS. If using the
optional intermediate stops, slide into the guide
ensuring the “ wedge “ is to the (grooved) front of
the side guide Leave loose, adjust to desired height
once the screen has been installed.
(Tip) Gently does it! Avoid overtightening the grub
screws when adjusting. This can cause damage to
the side guide and failure to work properly

To operate the screen. Pull down smoothly and simply clip into place. To open, TILT the bottom bar to release
from catches . Allow the screen to fully retract back into its cassette housing. .
Maintenance;
To keep your screen in perfect working order please keep the guides free from debris and dirt. Should you need to
clean the mesh, open the screen fully and simply lightly sponge with a mild cleaning agent and allow to dry before
retracting. Simply wipe the framework with a damp soapy cloth and dry with a towel.
Step 3 Preparing the Cassette prior to assembling the unit.
FACE FITTING Slide the face fitting Linto the groove
on the top of the cassette .
RECESS FITTING Insert the additional fluffy pile into
the grove in the top of the cassette. The M
bracket is directly fixed to the top of the recess and
the cassette simply clicks in n place .
Step 4 Assembling the unit prior to fitting.
Push the side guides into place ensuring the lugs are
correctly located. There should be no gaps as per pic
2.
Step 5 Installation of the unit.
FACE FITTING Offer the screen against the frame,
ensure the screen is square, then mark the fixing
points. Carefully drill the pilot holes. Loosely fit the
screen in place using suitable screws. Check
operation of screen, before tightening.
RECESS FITTING Offer the screen into the recess,
ensure the screen is square, then mark the fixing
points for M clips. Remove the screen, Directly fit
the M Clips to the top of recess. Click the screen
into place. Mark the fixing points for side guides.
Directly fix the side guides with suitable screws and
fittings if required.
Step 6 Operation of the unit.