FLYSCY FS-GT2E User manual

1
Transmier Operaon
Cauon: Never hold the trigger when turning on transmier. Ensure you understand all features
of transmier before using. Do not drop transmier or damage can occur.
1. Steering Wheel: Controls direcon of model (le/right).
2. Throle Trigger: Controls direcon of model (forward/reverse).
3. Power Switch: Turns transmier on and o.
4. Power LED: Indicates if transmier is on or o.
5. Power Check
6. Steering Trim: Adjusts the centering of the models front res.
7. Steering Dual Rate: Adjusts the amount the models front res turn front right to le.
8. Throle Trim: Adjusts the motors speed when trigger is at neutral posion.
9. Steering Reverse: Switch that will reverse the direcon of steering servo.
10. Throle Reverse: Switch that will reverse the direcon of the motor when trigger is moved.
11. Bind Buon: Used to bind transmier to receiver.
12. Baery Door: Remove door to install 4x AA baeries.
Transmier Features
1
2
3
4
56
7
8
9
10
11
12
Safety Precauons and Warnings
 This radio is not a toy and should not be operated by anybody under 14 years of age. Adult
supervision is required.
 Always ensure radio is on before turning on car or injury or damage can occur.
 Always perform system check to ensure throle and steering is working correct before
operang.
 Do not mix old and new baeries. It is recommended to use only alkaline baeries.
 Do not operate radio in rain or wet environment.
 Ensure Failsafe funcon is set before operang vehicle.
 Do no hold transmier by antenna while operang, this will decrease performance.

2
Binding Transmier to Model
1. Plug in bind plug to Bind Port on receiver.
2. Turn on cars on/o switch (located on boom of the car) and
LED on receiver will start to ash rapidly.
3. On transmier, hold down Bind Buon (item 11 in the image on
previous page) and turn on Power Switch (item 3 in image on
previous page). Connue holding Bind Buon unl LED on
receiver stops ashing and goes solid and then starts to ash
slowly.
4. Then turn o car and transmier and remove bind plug from
receiver.
5. Turn transmier on then turn car switch back on and check
steering and throle operaon to ensure controls are working
correctly.
6. If controls are not working correctly, turn of the cars switch and
turn on transmier and repeat steps 1-6.
Bind Port
CH1—Servo Port
CH2—ESC Port
CH3—Spare Port
Can be used for transponder
LED
Fail Safe Buon
Failsafe Seng
The failsafe will help prevent an out of control situaon if the transmier signal is lost.
How to Set the Failsafe:
1. Turn on transmier.
2. Turn on the receiver and ensure the LED on the receiver is on and solid.
3. Leave the throle on the transmier in the neutral posion.
4. Using the Failsafe Seng Sck on the Bind Plug wire, press the Fail Safe Buon on
the receiver. The LED will blink and then stop aer 3 seconds, that will indicate the
failsafe is set.
Test the Failsafe:
1. Turn on transmier.
2. Turn on the receiver.
3. Turn o the transmier and ensure the cars rear wheels do not roll. If rear wheels
roll repeat steps 1-4 in How to Set the Failsafe.