FMI Outland Living FMPPC2E-403 User manual

FIRE TABLE SOFT COVER
NUMÉRO DE PIÈCE 793
1 PC
® Registered trademark of FMI Brands Inc.
The OUTLAND flame is a registered trademark of FMI Brands Inc.
FMI BRANDS INC.
107 – 19052 26 Avenue | Surrey, B.C. Canada V3Z 3V7
Toll Free 1-888-514-1663 | Fax [phone]
COMPATIBLE WITH OUTLAND LIVING FIRE TABLE MODELS:
TICK SERIES NAME MODEL NUMBERS SERIES NUMBERS
OUTLAND FIRE TABLE FMPPC2E, FMPPC2E-1, FMPPC2E-403 400, 401, 403
SOFT COVER INSTALLATION GUIDE
1. Align Outland Living logo to the front and rear ends
of your Firetable. Align the corners of the soft cover to
the corners of the Firetable.
2. Pull two end corners over the tabletop frame,
ensuring they are square.
NOTE:
To provide extra slack for the following steps, tuck the
corners in between the tabletop and the top edge of
the end panel, as shown.

En-2 FIRE TABLE SOFT COVER INSTRUCTION MANUAL - #793
Fire Table Soft Cover
SOFT COVER INSTALLATION GUIDE (CONTINUED)
3. Pull the third corner over the tabletop frame.
Soft Cover corner shown tucked
underneath the bottom edge of
the end panel.
4. Pull the last corner over the tabletop frame. Realign
the four corners as needed so that they are square on
the tabletop.
5. Pull each corner down to the bottom.
6. Tuck each corner underneath the bottom edge of the
end panel to lock your Soft Cover in place.

1-888-514-1663 | WWW.OUTLANDLIVING.COM En-3
The Soft Cover is designed with a tapered fit so should be
expected to be fairly tight - BUT, REST ASSURED, IT WILL GO
ON. If you have problems putting the Soft Cover on the Fire
Table note the rectangular alignment of the cover with the fire
table; the correct orientation is necessary to put the cover on the
fire table.
SOFT COVER REMOVAL GUIDE
1. Un-tuck each corner of your Soft Cover from underneath the
bottom edge of the end panel.
2. Pull each corner up.
NOTE: To make it easier to pull off the first corner, tuck the other corners in between
the tabletop and the top edge of the end panel, as before in Step 2 of the installation
guide.
3. Carefully remove your Soft Cover one corner at a time.
MAINTENANCE
Simply use warm soap water to wipe down your cover to keep it clean.
Do not use bleach. Do not use abrasive cleaners.
The Soft Cover material contains UV blocking inhibitors to minimize fading, however, the cover
will eventually fade, especially when left continuously in the sun.
The Soft Cover is water resistant, but not completely waterproof. The seams may leak some rain
water but this will not harm your OUTLAND Fire Table.
Condensation may form under your Soft Cover and this is completely normal.
FIRE TABLE!
WARNING!
HOT SURFACE!
WARNING:
This is NOT a toy.
Never use the cover on your Outland Fire Table while the Fire Table is in operation.
After use allow the Fire Table to cool for at least 30 minutes prior to deploying the cover.

www.outlandliving.com
If you experience ANY problems with your Fire Table Soft Cover,
PLEASE DO NOT RETURN IT TO YOUR POINT OF PURCHASE!
Simply call us at 1-888-514-1663 or send an email to [email protected]
and we will answer all questions and/or concerns that you may have.
We take pride in our products at FMI Brands Inc.
and will strive to provide excellent customer service.
FIRE TABLE SOFT COVER
PART NUMBER 793
1 PCS
FMI BRANDS INC.
107 – 19052 26 Avenue | Surrey, B.C. Canada V3Z 3V7
Toll Free 1-888-514-1663 | Fax [phone]