FOOING ICM1241 User manual

INSTRUCTION MANUAL
ICE
MAKER
Item no: Z3912-SILVER
Model no:ICM1241
THANK YOU FOR CHOOSING OUR ICE MAKER
PLEASE READ THE MANUAL CAREFULLY BEFORE OPERATING

IMPORTANT NOTICES
When using an electrical appliance, please follow the following safety
precautions to reduce the risk of fire, electric shock, and injury:
1. Read all instructions before using.
2. Remove all packing material and carefully check your ice maker
to ensure that it is in good condition and that there is no
damage to the ice maker, power cord, and plug.
3. The first use should take place after the ice maker isplaced
appropriately and the transparent lid has beenopen for atleast
two hours.
4. Pure water isnot allowed to be used on this unit; instead, spring
water is recommended.
5. Ensure that the voltage corresponds tothe voltage range stated
on the rating label, and that the plug is connected to an earthed
socket.
6. If the power supply cord is damaged, itmust be replaced by the
manufacturer, its service agent, or a similarly qualified person to
avoid a hazard.
7. Do notinvert the icemaker, and do not tilt itat an angle greater
than 45 degrees.
8. To avoid the risk of electric shock, do not pour water on the
cord, plug, and ventilation. Do not immerse the appliance in
water or any other liquids.
9. Unplug the appliance before cleaning and after using.
10. Keep the appliance at least three inches from other objects to
ensure safe, efficient heating.
11. Do not use the accessories which the manufacturer does not
recommend.
12. This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning the safe use of the
1

appliance. Children should be supervised to ensure that they do
not play with the appliance.
13. Do not use the appliance close to flames, hot plates, or stoves.
14. Do not frequently switch on the power button (at least five
minutes in between) to avoid damage to the compressor.
15. Metal sheets or other electric objects cannot be inserted into the
appliance to avoid fire and short circuits.
16. Do not use the product outdoors.
17. Never clean the product with detergents or stiff instruments.
18. Please keep this instruction manual for future reference.
19. Warning: do not store explosive substances, such as aerosol
cans with flammable propellants in this appliance.
20. This appliance is intended to be used in household and similar
applications such as
−staff kitchens in shops, offices, and other working
environments;
−farmhouses and by clients in hotels, motels, and other
residential type environments;
−bed and breakfast type environments;
−catering and similar non-retail applications
21. When positioning the appliance, ensure the power supply cord
is not trapped or damaged.
22. Do not locate multiple portable socket outlets or portable power
supplies at the rear of the appliance.
23. The refrigerant and insulation blowing gas are flammable.
When disposing of the appliance, do so only at an authorized
waste disposal center. Do not expose to flame.
This symbol indicates the refrigerant R600a and the non-
metallic materials of the appliance are flammable. It's a warning
symbol. Warning: Risk of fire / flammable materials.
2

WARNING: When positioning the appliance, ensure the power
supply cord is not trapped or damaged.
WARNING: Do not locate multiple portable socket-outlets or portable
power supplies at the rear of the appliance.
Children should be supervised to ensure that they do not play with
the appliance.
To avoid contamination of food, please follow the following
instructions:
–Opening the door for a long time can cause a significant increase
in the temperature in the compartments of the appliance.
–Clean the surfaces regularly that can come in contact with food
and accessible drainage systems.
–Clean water tanks if they have not been used for 48 hours;
flush the water system connected to a water supply if water has
not been drawn for five days.
–If the refrigerating appliance is left empty for long periods, switch
off, defrost, clean, dry, and leave the door open to prevent molds
from growing within the appliance.
Please refer to the paragraphs below to know the methods of using
the appliance.
3

SPECIFICATIONS
Model No: ICM1241
Daily ice output: 12kg/24 hours
Ice storage capacity: 1.5L/600g
Refrigerant: R600a
Compression-type refrigeration: 120V/60Hz
Water tank capacity: 1.5L
Voltage: 120V
Frequency: 60 Hz
Power consumption: 120 W
Max overall dimensions (L×W×H): 320X225X300mm
Packing dimensions (L×W×H): 354X 270X 335mm
N.W: 7.75kg
G.W : 8.6kg
4

DESCRIPTION
9. Front housing
10. Ice shovel
11. Top cover
12. Transparent lid
13. Motor Mount
14. Back housing
15. Air vent
1. Micro switch support
2. Evaporator
3. Water Tray
4. Ice shovel board
5. Ice collecting tray
6. Water box
7. Control panel
8. Buttons
⑩
⑨
⑦
⒒
⒓
⒔
⒕
⒖
⑩
⑨
⑧
⑦
⑥
④
③
②
①
⑤
⑪
⑫
⑬
⑭
⑮
5

FEATURE
Quick ice making
Prompt when the ice is full, and water is insufficient
Bullet ice
Nine pcs ice can be made in eight minutes
1. During transportation, do not tilt the machine more than 45
degrees or reverse the machine, which may damage the
compressor and the sealing system.
2. Remove all packing materials, check the machine carefully, and
make sure that the machine, power cord, and plug are normal.
3. The machine should be on a level surface. To ensure sufficient
ventilation, the distance of the back of the ice maker to the wall
should be at least six inches. It also should be away from the
oven, radiator, or other heat sources.
4. Before using the machine for the first time, place the machine
appropriately and leave the transparent cover open for at least two
hours.
5. Make sure that the home voltage is consistent with the voltage
indicated by the machine.
6. Distilled water is not allowed. Mineral water is recommended.
6
PACKING LIST
No. Description Quantity
1 Ice shovel 1pc
2 Ice collecting tray 1pc
3 User manual1pc
4polybag1pc
5 Bubble2pc

CONTROL PANEL OPERATION
ICE FULL: Ice full alarm
ADD WATER: Water shortage alarm
ICE MAKING: Ice making
1). When plugged in, the "ICE MAKING" indicator flashes. Once the
power button is pressed, the "ICE MAKING" indicator is always on,
and then the ice maker makes ice blocks automatically. After the ice-
making process completes, the deicing process starts, and then the
ice-shoveling function kicks in. The process repeats continuously.
2). ADD WATER: water shortage alarm
When the "ADD WATER" light turns red, there is a water shortage
in the water tank. You need to add water and press the power
button to restart the machine.
7

3). ICE FULL: Ice full alarm
When the ice reaches the maximum capacity of the ice storage
container, the "ICE FULL" light flashes, and the machine stops. At
this time, the ice needs to be poured out. When the ice position is
lower than the full sensor position, the machine restarts
automatically.
4). ICE MAKING: Ice making
When this light is always on, it means that the ice maker is
producing ice.
OPERATING INSTRUCTIONS
Step 1
Open the lid, take out the basket, and add water to the reservoir. Note:
There is a full- scale MAX in the reservoir. The water should not
exceed the MAX position. If the water exceeds the full-scale MAX,
you need to open the bottom drain plug, release the excessive water,
and cover it with the transparent cover.
Step 2
Plug in the ice maker and press the power button to start the machine.
1. The shape of the ice produced in the first three cycles is
relatively smaller and irregular.
2. When the ice basket is full, please take out the ice immediately. Do
8

not let the ice overflow the ice basket.
CLEANING & USE GUIDANCE
1. Clean the inner liner, ice collecting tray, water box, ice shovel,
and evaporator frequently. When cleaning, unplug the unit and
remove the ice cubes. Use a diluted solution of water and
vinegar to clean the inside and the outside surfaces of the
ice maker. Do not spray Ice maker with chemicals or diluted
agents, such as acids, gasoline, or oil. Rinse thoroughly before
starting.
2. Allow enough room around the ice maker for adequate
ventilation. Do not use mechanical devices or other means not
recommended by the manufacturer to accelerate the defrosting
process.
3. After the machine has been standing idle for a long period of
time, the restart may trigger the air blockage inside the pump
and causes the pump to draw insufficient water, followed by the
flashing of water shortage indicator "ADD WATER." Under such
circumstances, press the power button and start the ice maker
again.
4. To ensure the cleanness of ice, please change the water at
least once a day. If the ice maker is not used for a long time,
please drain the water and clean it up.
5. Several reasons can trigger compressor protection which
normally lasts three minutes. These reasons include but not
limited to the shortage of water, the overflow of ice, or power
failure.
6. Always use fresh water before starting ice production, either at
initial installation or after a long shut-off period.
9

TROUBLESHOOTING
1. Please note: if a power failure occurs due to the disconnection of
the power cord, or the power button has been switched off during
an ice-making cycle, small ice chips may be formed and lodge in
the automatic shovel causing it to jam. The ice chips can be
removed by carrying out the following steps: first, disconnect the
power cord; next, gently push the shovel to the rear of the cabinet;
finally, restart the ice maker.
2. Please check if the water reservoir is flat when the ice shovel can
not remove the ice from the ice basket. If not, please push the ice
shovel gently by finger, then press the POWER button to restart.
PROBLEM POSSIBLE CAUSE SUGGESTED SOLUTIONS
ressor worksThe comp
abnormally with a
buzzing noise
The voltage is lower
than recommended
Stop the ice maker and do not
restart until the voltage is normal.
indicator
Water shortage
light is on
1.There is no water
2.The pump is full of air
1.Add to some water until it
reaches MAX position
2.Press POWER button to restart
Indicator lights on
display are not on Blown fuse/ No power Replace fuse / Turn power on
large
sticking
The Ice made is too
and with pieces
together.
Ice of previous cycles
left in the water tray
Take out the ice under the
STANDBY mode.
The ice making
process was correct,
but no ice came out?
1.
2.
The compressor
has no refrigerant
Compressor
damaged
Call the service hotline
10

1. If the power cord isdamaged, it must be replaced by the
manufacturer, its service agent, or a similarly qualified person to
avoid a hazard.
2. Fill with potable water only.
3. In normal circumstances, the surfaces of the compressor and the
condenser can reach between 158°and 194°F, hence the higher
temperature of the immediate surroundings.
4. Due to fast freezing, ice cubes may be opaque. Thisisbecause
of the air trapped in the water, which does not affect the quality
or the taste of the ice.
5. This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities or
lack of experience and knowledge unless they have been given
supervision or instruction concerning the safe use of the
appliance.
3. Fan motor damaged
All indicators twinkle
simultaneously
1. Water tray is blocked
by ice cube
2. The motor is stuck, or
the motor falls off, or the
motor is damaged
3. Micro switch damaged
Unplug the power to take out the
ice which blocking the tray, then
plug the power and press the
POWER button, the machine will
restart 3mins later.
The machine has been
working, but the water
has been warming
Solenoid broke down Replace the solenoid valve
When the ice is full,
the machine does not
display the ICE FULL
Icon
1. Ice full sensor
damaged
2. Solar light interference
1. Replace the ice full sensor
2. Making ice indoor
3. Call the service hotline
11

6. Children should be supervised to ensure that they do not play
with the appliance.
7. Do not immerse the ice maker in water.
Correct Disposal of this product
This marking indicates that this product should not
be disposed of with other household wastes. To
prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of
material resources. Please use the return and collection
systems or contact the retailer where the product was
purchased to return your used device. They can take this
product for environmentally-friendly recycling.
12

Thank you for purchasing this product! If you have any questions about
the product, such as missing parts, damaged products, product
assembling, and operation, please contact us via Amazon Message or
customer service number: 213-4467172 or 661-4358826
IMPORTANT
Please call our customer service department for any consulting:
213-4467172
661-4358826
(8:30am - 5:30pm P.S.T.)
DATED PROOF OF PURCHASE IS REQUIRED FOR WARRANTY
SERVICE.
AVIS
Veuillez appeler le service à la clientèle pour toutes questions au:
213-4467172
661-4358826
(8:30am - 5:30pm P.S.T.)
PREUVE D’ACHAT ORIGINALE REQUISE POUR SERVICE DE
GARANTIE.
IMPORTANTE
Sólo hay que llamar nuestro departamento de servicio
al cliente en caso de tener preguntas o inquietudes:
213-4467172
661-4358826
(8:30am - 5:30pm P.S.T.)
SE REQUIERE PRUEBA DE COMPRA CON FECHA PARA SERVICIO
BAJO GARANTÍA.
Address : 9733 Topanga Canyon Blvd. APT310, Chatsworth, CA 91311
Phone: [phone] or 661-4358826