Forums + Surfaces VECTOR SEATING SYSTEM User manual

VECTOR SEATING SYSTEM
LED WIRING INSTRUCTIONS
page 1 of 2 | Rev. 12-17-18
© 2018 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
T 800.451.0410 | www.forms-surfaces.com
STEP BY STEP
CAUTIONS & WARNINGS
Prepare Incoming Power
• Before pouring concrete footer, run properly sized conduit and cabling to each
bench leg containing an LED driver according to local code requirements.
Refer to bottom view figure with dimensions for conduit entry envelope size
and location on bench leg.
Note: Conduit should not protrude more than 2" above mounting surface.
• Forms+Surfaces is not responsible for site preparation and footings.
• Forms+Surfaces is not responsible for any injuries or damage to property incurred while wiring or installing luminary, or resulting from incorrect
wiring or installation.
• Before proceeding with wiring of luminary, check to ensure that all applicable site wiring and safety codes have been followed. Installation
should be performed only by qualified individuals.
FOR VECTOR SEATING SYSTEM CONFIGURATIONS WITH A STANDALONE BENCH
Locate Wires
• Remove four screws on access door at
base of leg, and remove access door.
• Locate black, white, and green wires from
driver.
Note: Driver rated for 100-277VAC supply
power at 1.5 amps. Installation of a surge
protector as part of each unit’s wiring is
recommended.
51
4
"
(Between Bench
Mounting Holes)
8
7
16
"
7
16
"
1
1
8
"
LEG CENTERLINE
3
1
2
"
1
1
2
"
CONDUIT MUST ENTER
BENCH LEG THROUGH
THIS AREA
BOTTOM VIEW

VECTOR SEATING SYSTEM
LED WIRING INSTRUCTIONS
page 2 of 2 | Rev. 12-17-18
© 2018 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
T 800.451.0410 | www.forms-surfaces.com
Re-Install Access Door
• After testing bench lighting, re-install access door with four
original screws.
STEP BY STEP FOR VECTOR SEATING SYSTEM CONFIGURATIONS WITH A STANDALONE BENCH
Connect Wires
• Insert ground (green), neutral (white), and positive (black) wires
into provided wire nuts, being sure to match wire color codes
from junction box to bollard.
• Tighten wire nuts until exposed wire ends are below bottom of wire nut.
• Inspect all wiring and connections before turning power supply on.
• Refer to installation instructions for additional information.
Prepare Wires
• Prepare wiring from site junction box and bollard by
stripping and removing .47" (11-13mm) of insulation. Wire
used should be 22-14 AWG copper conductors.
.47"
(11-13mm)