Outsider PLATEAU STREET 207 Installation instructions manual

PLATEAU STREET
#207 MOUNTING GUIDE
Kigkurren 8A Islands Brygge DK2300 Copenhagen · out-sider.dk

02
Seat 900
•6 pcs M8x100 allen key screw
•6 pcs M8 nuts
•6 pcs M8 washer
Tools (not included)
•Allen key set
•Socket wrench set
•Screws and bolts for the mounting on the surface
PLATEAU PICNIC STREET
Developed by out-sider in collaboration with Holscher Design 2019.
INDEX: PAGE
Item list ......................................................................................02
Assembling legs and table........................................................03
Assembling laminate seats to the legs....................................04
Assembling seats to table frame.............................................04
Cleaning and maintenance .....................................................05
ITEM LIST ADD-ONS
Add-ons, are not included with standard product
1x Point Sun
f. Seat
2x Short leg with lange
(204 1010)
2x Street leg (204 3030)
1x logo disc
(195 9040)
3x Seat 1800 or Seat 1250
2x disc
(195 9041)

03
1 : ASSEMBLING LEGS AND TABLE
A: Place one leg at the end where there is no hole through the frame. Fixate the leg with M8x100 bolt, nut and
washer. B: lip the assembly over, place the other leg underneath the frame. Insert the disc, and ixate leg and
disc with M8x100 bolt, nut and washer.
Table and leg with flange
Make sure the lange is placed
lat against the frame when irmly
tightening the bolt.
ATTENTION
- Only place laminate on a safe, or
soft surface to prevent damage to the
laminate.
A B
M8x100
Nut
Washer
Nut
Washer
M8x100
Logo disc

04
2 : ASSEMBLING LAMINATE SEATS TO LEGS
Use the included M8 x 100mm allen key bolts to ix the sitting surface to the ixated surface
bracket. Tighten the bolts and nuts with allen key no 6. and a 17mm spanner tool.
Seat 1800/1250 and leg with flange
Make sure the lange is placed lat
against the seat frame when irmly
tightening the bolt.
ATTENTION
- Only place laminate on a safe, or
soft surface to prevent damage to the
laminate.
- Repeat procedure with the next
1800/1250 seat for 207 Street.
M8x100
Nut and washer

05
3 : ASSEMBLING SEATS TO TABLE FRAME
The two seats are placed over the table frame and fastened with M8x100, nut and washer. Tighten
irmly. Remember to it disc before tightening the bolt.
M8x100 bolt
M8 nut and
washer

06
CLEANING
Clean the laminate surface with warm water and a soft sponge.
NEVER use the abrasive “green” side of the sponge. Use an ordinary universal cleaner.
Diicult dirt must be removed with a nano sponge and water. Please take a closer
look at our website, or contact us for information.
Kigkurren 8A
Islands Brygge
DK2300 Copenhagen
out-sider.dk
[phone]