Franke Centinox CEN-SP-304 User manual

Centinox
EN Installation manual Kitchen Faucet
ES Manual de instalación Grifo de cocina
FR Manuel d‘installation Robinet de cuisine
CEN-SP-304

3
EN
Table of contents
Overview 4
Contents in box 4
Technical data 5
Installation instructions 5
Cleaning and maintenance 7
Replacing the cartridge 7
General maintenance 7
Spare/replacement list 8

4
EN
Overview
Contents in box
Note: Contact us immediately if you see inconsistencies.
phone: [phone]
website: www.franke.us/ks
email: ks-customerservice[email protected]
1. Faucet Assembly
2. Aerator Key
3. Hex Key
4. Rubber Washer
5. Plastic Flange
6. Fixing Plate
7. Fixing Nut
8. Supply Hoses
2
1
8
3
4
5
6
7

5
EN
Technical data
Operating data Value
Operating pressure (ideal) 60 PSI 4 bar 400 kPa
Operating pressure (max.)* 115 PSI 8 bar 800 kPa
Operating pressure (min.)* 30 PSI 2 bar 200 kPa
Water temperature (ideal) 140°F 60°C
Water temperature (max.) 158°F 70°C
Hole Size For Faucet 1 3/8“ 35 mm
Installation instructions
1. Remove all contents from the package
and check for completeness.
2. Turn o water supply.
3. Cut a mounting hole 1 3/8“ diameter
(35 mm) in the desired mounting
surface (if one isn’t available).
4. Ensure Base O-ring (2) is in place in the
Faucet Base (1) (g. 2A).
5. Insert the faucet into the hole, hoses
rst (g. 2B).
2A
1
2
3
5
6
4
2B
Certies this faucet complies with ASME A112.18.1 / CSA B125.1, NSF/ANSI/CAN 61-
2020 (AB100 compliant, Q<1 ) & NSF 372. The faucet also complies with water usage
requirements of the California Energy Comission and the US Department of Energy.

6
EN
Attention: Base-O-Ring (2) should be
sitting between the countertop and
faucet base.
Do not use putty or other sealant at this
location.
Notes: Solid surface installation: The
countertop mounting surface needs to
be at and free of debris; otherwise the
faucet may not sit properly and could
leak.
6. Install the mounting hardware to the
mounting shank of the Faucet Base (1)
underneath the mounting surface in
the following order: Rubber Washer (3),
Plastic Flange (4) and Fixing Plate (5)
(g. 2B).
7. Secure the faucet by tightening the
Fixing Nut (6) onto the mounting shank
of the Faucet Base (1) and tightening
the screws in Fixing Nut (6) (g. 2B).
8. Connect the Flexible Supply Hoses (7)
to the water supply in the home
(g. 2C).
9. Remove the Aerator (8) using the
Aerator Key (9) (g. 2D).
10. Turn on water, ush the faucet and
Aerator (8) to remove any debris and
check for leaks (g. 2E).
11. Reinstall the Aerator (8) and ensure
everything is functioning properly.
2C
7
7
2D 2E
8 8
9

7
EN
Cleaning and maintenance
Replacing the cartridge
1. Shut o the water supply to the faucet.
2. Turn on the faucet briey to relieve any
pressure inside the faucet.
3. Move the faucet handle to the “OFF”
position.
4. Remove the set screw from the Handle
Assembly (A) using a 2.5 mm hexkey.
5. Pull the Lever Handle (A) and Cartridge
Cap (B) from the faucet body.
6. Unscrew the Cartridge Lock Nut (C).
7. Lift ceramic Disc Cartridge (D) from
the body and replace it with a new one.
Ensure the two lugs on bottom of the
cartridge sit properly in the allocated
holes at the base of the body.
8. Re-assemble faucet in reverse order.
9. Test for leakage.
General maintenance
Clean aerator periodically for any buildup
(g. 2D and 2E).
Do not use harsh detergents, solvents,
chemical agents, especially CHLORINE
or metallic sponges as these can damage
the surface nish. Clean only with a soft
sponge and soapy water.
Do not store chemicals or cleaning
agents in the immediate vicinity of the
faucet and connection hoses. Chemical
vapors could cause damage.
30 mm
106 in-lbs
ABCD
2.5 mm

8
EN
11
11.1
2.2
78910
12
5
5.1
6
2
2.1
2.3
2.2
1
1.1
1.1
1.2
4
3
13 14
1F5501 Spout Assembly
1.1 F5502 Spout O-ring Kit
1.2 F5503 Spout Bushing
2F5504 Spray Head Assembly
2.1 F5505 Set Screw
2.2 F5506 Set Screw Cover
2.3 F5507 Aerator
3F205513 Check Valve
4F3306 Aerator Key
5F5508 Spout Arm Assembly
5.1 F5509 Spout Bushing Kit
6F5510 Set Screw
7F5511 Cartridge
8F5512 Cartridge Nut
9F5513 Cartridge Nut O-ring
10 F5514 Cartridge Cap
11 F5515 Lever Handle
11.1 F5516 Set Screw
12 F5517 Fixing Kit
13 F5518 Hot Supply Hose
14 F5519 Cold Supply Hose
Spare/replacement list

9
EN
For any further information about our products, about the installation of them or about
the warranty please contact our customer service department:
Franke Home Solutions
North America, LLC
800 Aviation Parkway
Smyrna, TN 37167, USA
Phone: [phone]
[e-mail]
Franke Kindred Canada Ltd.
1000 Franke Kindred Way
Midland, ON LR4 4K9
Phone: [phone]
[e-mail]
Warranty website: https://www.franke.com/us/en/hs/support/warranty.html