Franklin Sprint R850 Specification sheet

Get Started

Your R850 Mobile Hotspot
micro-USB
charging
port
Power/Wake device/
Navigation buttonLCD screen
Get Started Guide
(This guide)
micro-USB
charger
Battery
Battery
Cover
What’s in the Box

Set Up Your Hotspot
Insert the Battery
1. Remove the back cover using the thumb catch on
the bottom edge of the hotspot.
2. Align the battery’s contacts with those inside the
battery compartment and gently press down until
the battery is seated.
3. Replace the back cover.
Note: Your Hotspot comes with a nano-SIM card
preinstalled. Do not remove the nano-SIM card.
Charge the Battery
1. Insert the small end of the USB cable into the
micro-USB charging port on the right side of the
hotspot.
2. Plug the charging adapter into a standard
AC power outlet.
Get Ready
1. Make sure you are in an area covered by the Sprint
network (not roaming).
2. Make sure the device you are trying to connect
to your Hotspot has its Wi-Fi® (wireless network
connection) mode turned on.
3. Make sure your Hotspot is set up on your
Sprint account. (Sign on to your account at
sprint.com/mysprint to verify.)

Hotspot LCD Screen
Power Up the Hotspot
To turn your Hotspot on or o, press and hold the
Power Button on the front of the device for at least
two seconds.
Main Screens
Your Hotspot has a series of screens that
let you view device information and system alerts.
Press the Power Button (Navigation Key) to cycle
through the following:
• Signal strength/Battery Status
• WiFi Name
• WiFi Password
• Settings
• Admin Password
• Data Usage

Connect to Your Hotspot
Connect a Device to Your Hotspot via Wi-Fi
1. Turn on your Hotspot and your
Wi-Fi-enabled device.
2. Open the Wi-Fi application or controls on the
computer or Wi-Fi-enabled device that you
want to connect to your Hotspot.
3. Find your Hotspot’s Wi-Fi name and enter your
password to connect to the Internet.
Note: Your Wi-Fi name (SSID) and password appear
on the Hotspot LCD display.