Fredenstein Artistic Microphone Preamplifier SE
Gain Control:
Microphone Preamplifier Gain Control, minimum +20 dB, maximum +65 dB
POL – Polarity Control:
Pushing the POL switch selects the polarity, when lit (blue), the output polarity is reversed.
Otherwise the true, non-reversed, polarity is selected (normal operation).
PAD – Input Attenuator:
Setting the PAD switch (orange light) activates a 20dB attenuator at the input allowing line level
signals to pass through the preamplifier (note: Pad is not affecting the DI input)
Lo -cut – High Pass Filter:
When lit (green), frequencies under 120Hz will be softly attenuated.
P48 Phantom Po er:
Most FET condenser microphones as well as some other microphones with built-in amplifiers
require +48V Phantom Power. Setting the P48 switch (red light) enables +48V through the balanced
microphone line. Please check your microphone documentation if you are not 100% sure. Enabling
P48 on microphones not designed for P48 might cause severe damage to the microphone. The DI
input is not supplied with Phantom Power.
DI – Direct Input:
The most common use for the DI input is to connect instruments like guitars directly to the Artistic
Pre. The input impedance is greater than 100 Ohms to insure compatibility with most instrument
pickups. After inserting a balanced (Tip-Ring-Sleeve) or an unbalanced (Tip-Sleeve) plug, the
balanced microphone input through the box or rack is automatically disabled.
Technical Data Artistic Mic Pre SE:
Frequency Response : 20 Hz – 20,000 Hz, +/- 1 dB
Distortion : < 0.02% at +4 dBu output level
Input Noise : < -127 dB
Input Impedance : > 1500 Ohms
DI Impedance : 2 MOhms
Max. Input Level : + 24 dBu, Pad activated
Max Input Level DI : + 18 dBu balanced or unbalanced
Output Impedance : 600 Ohms
Max. Output Level : + 26 dBu
Input Attenuator : - 20 dB (switchable)
Fredenstein Artistic Mic-Pre SE Manual V1.0, Nov 1, 2022 Page 3