FREEWAY MT600-24T Assembly instructions

INTRODUCTION
Thank you for purchasing Freeway Med-Tech’s Medical Grade Monitor. With a 24-inch display, the Medical
Grade Monitor offers optimal combinations of performance and power savings. With fully-integrated point-
of-care modules within an elegant, space-saving design, the Medical Grade Monitor is the optimum solution to
enhance workow and service, while paired with NHS Hospital Standard MFF PC, or thin clients.
Please take a few moments to review the contents of this document to ensure that the setup and startup
proceed smoothly. The Monitor is ready for use, out of the box, in its default conguration when powered
by the power source provided. The following documentation offers guidance on the hardware elements
and features of the monitor. Please refer to your device provider for information pertaining to the software
operating system or software applications.
The MT600-24T supports VESA standard (100x100mm) mounting brackets and arms. Attach the bracket or
the arm to the back of MT600-24T, then use screws (4 x M4x12mm) to x the VESA bracket or arm.
BASIC
OPERATION
GUIDE
MT600-24T
Mains Powered Medical-Grade Monitor
Package contents
1 MT600-24T Mains
Powered 24in Touch
Screen Monitor
1 Medical Grade AC-DC
power adapter with
orange curly power cord
1 Basic Operation Guide
1 Cable pack

PRECAUTIONS
• Always exercise care when operating and handling
the Medical-Grade Monitor.
• Never disassemble any portion of the enclosure, as
this will void any product warranty on the Monitor.
• Do not use any AC/DC adapter other than the
one provided with the device or a replacement
acquired from the manufacturer.
• In the unlikely event that smoke, abnormal noise or
strange odour is present, immediately power down
the Monitor and disconnect all power sources.
Please report the problem to your device provider
immediately.
freewaymedtech.com
BASIC FEATURES
The Medical-Grade Monitor integrates a bright 24” display with a high performance system and USB ports for
a comprehensive point-of-care solution.
Powering ON and OFF
Please use the AC-DC adapter with the Medical-Grade Monitor for the power supply. To activate the
Medical-Grade Monitor, push and quickly release the Power Button and the display will come on in a few
seconds.
CLEANING THE MT600-24T
The screen
• A screen cleaning solution that is alcohol-free and non-abrasive can be used to clean the touch screen.
• Cleaning with a micro-ber cloth is recommended.
• Please spread the solution onto the cloth and then clean the touch screen.
The anti-microbial enclosure
• Use a soft/non-abrasive cloth moistened with water to clean the enclosure.
• If using a cleaner, an alcohol-free and oxide-free cleaning liquid is recommended.
• To prevent scratching the anti-microbial coating, please wipe gently.

MT600-24T Basic operation guide
MEDICAL – GENERAL MEDICAL EQUIPMENT
AS TO ELECTRICAL SHOCK, FIRE AND MECHANICAL
HAZARDS ONLY IN ACCORDANCE WITH ANSI/AAMI
ES60601-1 (2005) + AMD (2012) & “CAN/CSA-C22.2
No. 6060-1 (2008) + (2014)
B D E
HF G H
A C
FRONT REAR
100x100 VESA mounting
TOUCH
SCREEN
I/O PORTS
The MT600-24T Monitor has a comprehensive set of I/O ports. The following ports are located along
the lower rear edge of the unit.
*The monitor’s enclosure may look
different to production models.
ADC-in EUSB Type-B input
BUSB Type-B for touch screen connection FPower button
CUSB 3.0 GFunction buttons
DHDMI (1.4a) HStereo speaker

v2.0 0123freewaymedtech.com