For Your Safety
I
•Readlnstmctions: All the safety and op
erating instructions should be read
before the appliance is operated.
• Retain Instructions: The safety and
operating instructions should be
retained for future reference
•_: All warnings on the
appliance and in the operating in
structions should be adhered to
•Followlnstmctions:All operating and
useinstructions should be foJIowed.
!_//_ti:: :
Power Sources: This video product
should be operated only from the
type of power source indicated on
the marking label. If you are not sure
of the type of power supply to your
home, consult your appliance dealer
or local power company. For video
products intended to operate from
battery power, or other sources, refer
to the operating instructions
Grounding or Polarization: This video
product is equipped with a polar
ized alternating current line plug (a
plug having one blade wider than
the other). This plug will fit into the
power outlet only one way. This is a
safety feature If you are unable to
insert the plug fully into the outlet,
try reversing the plug If the plug
should still fail to fit, contact your
electrician to replace your obsolete
outlet Do not defeat the safety pur
pose of the polarized plug
IMPORTANTSAFETYINSTRUCTIONS I
Alternate Warnings: This video prod Water and Moisture: Do not use this
uct is equipped with a three wire video product near water for ex Outdoor Antenna Grounding: If an
grounding type plug, a plug having
a third (grounding) pin This plug
will only fit into a grounding type
power outlet This is a safety feature
If you are unable to insert the plug
into the outlet, contact your electri
cian to replace your obsolete outlet
Do not defeat the safety purpose of
the grounding type plug
Overloading:Do not overload wall out
lets arm extension cords as this can
result in a risk of fire or electric shock
Ventilation: Slots arm openings in
the cabinet are provided for ventila
tion, to ensure reliable operation of
the video product and to protect it
from overheating, and these open
ings must not be blocked or coy
ered. The openings should never
be blocked by placing the video
product on a bed, sofa, rug, or other
similar surface
This video product should not be
placed in a built in installation such
as a bookcase or rack unless proper
ventilation is provided or the manu
facturer's instructions have been ad-
hered to. This video product should
never be placed near or over a radia
tar or heat register
Attachments: Do not use attachments
not recommended by the video
product manufacturer as they may
cause hazards
ample, near a bath tub, wash bowl,
kitchen sink, or laundry tub, in a wet
basement, or near a swimming pool,
and the like
Power-Cord Protection: Power sup
ply cords should be routed so that
they are not likely to be walked on
or pinched by items placed upon
or against them, paying particular
attention to cords at plugs, conve
nience receptacles, and the point
where they exit from the appliance
Accessuries: Do not place this video
product on an unstable cart, stand,
tripod, bracket, or table The video
product may fall, causing serious in
jury to a cMd or adult, and serious
damage to the appliance. Use only
with a cart, stand, tripod, bracket, or
table recommended bythe manufac
turer, or sold with the video product.
Any mounting of the appliance should
followthe manufacturer's instructions,
and should use a mounting accessory
recommended by the manufacturer
An appliance and
cart combination
should be moved
with care Quick
stops, excessive
force, and uneven
surfaces may
cause the appliance and cart combi
nation to overturn
outside arCenna or cable system is
connected to the video product, be
sure the antenna or cable system is
grounded so as to provide some pro
tection against voltage surges and
built up static charges. Section 810
of the National Electrical Code, ANSI/
NFPA No 70, provides information
with respect to proper grounding
of the mast and supporting struc
ture, grounding of the lead in wire
to an antenna discharge unit, size of
grounding conductors, location of
antenna discharge unit, connection
to grounding electrodes, and require
ments for the grounding electrode
EXAMPLEOFANTENNA GHOUNDINGA5
PERNATIONALELECTRICALCODE
dlound _Antenna Lead
C/amp_ Ikl4"m Wi,e
[Equl_nent _. ][I_-Unit (NEC
[ . ?m )1 ECTION
÷ GIounding
Powei Selvicedrounding Conductors
Electrode System(NEC (hiE( SECTION
ART250 PARTH) 810 21)
Power Lines: An outside antenna sys
tern should not be located in the
vicinity of overhead power lines or
other electric light or power circuits,