Fujitsu ScanSnap S300 Configuration guide






Plastic Rollers
Feed Rollers
White Sheets
Glass
Pick Roller
Pad Assy


EjectRollers
Cleaning Instructions for
ScanSnap S300/S300M
It is recommended that these items be
cleaned EVERY 1,000 SCANS
Consumables Part Number
Consumable Kit CON-3360-001A
Cleaning Kit SC-CLE-WGD
Using F1 Impregnated Cleaning Wipes

Pad Assy
Wipe downwards. When cleaning take care to prevent the cleaning wipe from catching on the
metal parts


Turn the Scanner OFF while cleaning the following locations
ADF Glass Surfaces x 2
Located on the ADF cover and opposite side. Clean lightly.
Pick Roller
Clean lightly taking care not to scratch the surface.
P.T.O.
BEFORE CLEANING
Open the ADF while pulling the cover
open lever
ADF Cover
Open Lever

Plastic Rollers x 4
Clean lightly while rotating with your finger. Take care not to roughen the surface.

White Sheets x 4
White strips along the edge of the glass. Clean lightly.


Feed Rollers x 2
Clean lightly taking care not to roughen the surface.
For further information please refer to the
ScanSnap S300/S300M Operators Guide
which can be found on our Website:
http://www.fujitsu.com/emea/products/
January 2010
Using F1 Impregnated Cleaning Wipes
Eject Rollers x 2
Clean lightly taking care not to roughen the surface.

Turn the Scanner ON while cleaning the following locations
PFU Imaging Solutions Europe Ltd Cleaning Instructions for ScanSnap S300/S300M
To rotate the Feed and Eject Rollers, open the ADF and hold down the SCAN button for three seconds
while the power lamp lights is blue. The rotation can be repeated as long as the ADF is open.
As a guideline, seven presses of the POWER button make the rollers rotate one full turn.
Hold down the SCAN button for three seconds
Rollers will rotate





Plastic Rollers
Feed Rollers
White Sheets
Glass
Pick Roller
Pad Assy


Eject Rollers