1 2
NNL
L1
NBlack
Blue
Yellow-Green
Motor
1
Receiver box
Centralis receiver RTS
1 EKK 3 G 1,5 mm² 2 EKK 4 G 1,5 mm²
GProgramming button
D Up
EStop
FDown
- The box shall be mounted with the cables entering and exiting
from the bottom of the box.
- The box shall not be mounted in a metal casing.
- All metal objects in the vicinity of the receiver will impair the
reception.
- The antenna is built-in.
- Minimum distance Between floor/ground and receiver 150 cm.
Between two receivers 20 cm.
Mellan sändare och mottagare 30 cm.
N.B.! Only one motor must be connected to the Centralis box!
Receiver box:
Press the programming button, B, inside the receiver box approximately
2 seconds, until the indication lamp, A, starts to shine.
The receiver is now, during one minute, ready to receive the signals from
the transmitter.
Transmi er:
Press shortly the programming button of the transmitter, G.
The indication lamp in the receiver box then starts to twinkle, which shows
that the transmitter's signal is memorised and programmed.
Open the lid of the receiver box.
Receiver box:
Press the programming button, B, inside the receiver box approximately
10 seconds until the indication lamp, A, starts to shine.
Ins alla ion
Receiver box
Transmi er
Cable drawing
Wire diagram
Programming of ransmi er and receiver.
Dele e programming.
L
N
N
Feeding live
Feeding neutral
Motor neutral
Motor up
Motor down
NL
A Indication lamp
B Programming button
C Push button for
manual testing
L
N
Not in use
Not in use
Brown
Open the lid of the receiver box.
