Furinno NT-13013 User manual

Assembly Instruction
Customer Service
Tel/Fax: [phone]
Toll Free: 773.299.8111 (Mon - Fri 9am - 5pm)
Email: [email protected]
WARNING:
>This unit has been designed to support the
maximum loads shown. Exceeding these
load limits could cause sagging, instability,
product collapse, and/or serious injury.
>DO NOT allow children to climb on unit.
>Put heavier items on lower shelves.
its Space. its Budget
www.furinno.com
Slot in Panel(I)to Panel(F)(H)(G).
Attach Plastic Drawer Front Panel(6)to
Panel(F)&(G).
STEP 8
Attach Panel(F)&(G)to Panel(H).
Repeat the same method as Step 3.
STEP 7
Recommended Maximum Weight
Furinno Ubah No Tools 4-Drawers Chest
NT1301320140425
MODEL : NT-13013
23.4”(W) x 29.2”(H) x 16.2”(D)DIMENSION :
30
*Unit in Pound(lbs)
Upright the unit.
Slide in 4 sets of drawer to the unit.
Insert Runner Stopper(3)to the pre-drilled
hole of Panel(F)&(G),as shown.
STEP 9
6
Tool RequiredTool RequiredNo Tools Required
Recomm. 1 PersonRecomm. 2 Person
Approx. 5 minutesApprox. 10 minutesApprox. 15 minutesApprox. 30 minutesApprox. 40 minutes

STEP 5
Face down the unit and attach Panel(J).
Insert Corner Pin(5)into the pre-drilled
holes of Panel(J).
STEP 6
STEP 3
Attach Panel(C)&(D)to Panel(E).Turn on
Cam-Lock and fix into the pre-drilled nut.
Turn off Cam-Lock when the panel were fixed.
Attach Panel(A)&(B)to Panel(C)&(D).
Repeat the same method as Step 3.
STEP 4
STEP 1
Fix Lock Switch(2)into the Cam-Lock of
Panels(C)(D)(E)(F)(G)&(H).
Insert Plastic Dowel(1)to Panel(C)(D)&(E).
STEP 2
turn on turn off
unfinished
edge
USEFUL HINTS BEFORE YOU START:
1. Read each step carefully before starting.
2. It is important that each step is performed in correct order to avoid difficulties.
3. Identify, sort and count the parts before assembly.
4. Assemble your furniture on packaging cardboard to prevent scratch or damage.
5. Clean the product with mild cleanser using soft damped cloth. Do not use harsh or abrasive cleanser.
6. Using uncompatible hardware might cause damage to product.
1
2
3
12pcs
42pcs
8pcs
A 1pcs
Top Panel
Runner Stopper
No Hardware List Qty No QtyParts List
Plastic Dowel
Lock Switch
4
5
6
10pcs
4pcs
4pcs
Plastic Drawer
Front Panel
Plastic Pin
Corner Pin
B
C
1pcs
1pcs
Left Side Panel
Bottom Panel
D
E
F
1pcs
1pcs
4pcs
Drawer Left Side Panel
Right Side Panel
Front Bar
G
H
4pcs
4pcs
Drawer Rear Panel
Drawer Right Side Panel
I
J
4pcs
2pcs
Back Panel
Drawer Base
slot in
(1)x12pcs
(2)
unfinished
edge
unlocked
locked
unfinished edge
(5)x4pcs
(4)x10pcs
(A)
(E)
(J)
(B) (F)
(G)
(C)
(I)
(H)
(C)
(D)
(E)
Cam-Lock
Insert Plastic Pin(4)into pre-drilled holes
of Panel(J).