FURNITURE CONCEPTS 066 Camp Ladder End Bunk User manual

FURNITURECONCEPTS
®
800 969 4100 [email protected] www.furnitureconcepts.com
FURNITURECONCEPTS
®
066 Camp Ladder End Bunk
Assembly and Parts Good for 30, 36, 39 Sizes
Each Bed Consists of:
- 2 Bottom Bed Ends: 2 Pre-Drilled Holes on
each side and one Pre-Drilled hole at the top of
each side.
- 2 Top Bed Ends: 2 Pre-drilled Holes on each
side and one Pre-Drilled hole at the bottom of
each side and a groove carved from the top of
each side.
- 8 Bed Slats
- 4 Bed Rails
- 2 Safety Rails
Hardware:
- 16 Headlock Spider Head Fasteners 4 ½”
- 24 Square Head Fasteners 1 ¼”
- 4 Metal Connector Pins
- 1 Headlock Spider Drive Bit
Assembly:
1. Connect Bottom End Panels with 2 Bed Rails using
8 Headlock Spider Head Fasteners with a cordless
drill and the Spider Drive Bit. DO NOT over tighten.
2. Insert the 4 Metal Connector Pins in the pre-drilled
holes at the top of each Bed End Panel.
3. On the floor, connect Top Bed End Panels with 2 Bed
Rails using 8 Headlock Spider Head Fasteners with a
cordless drill and the Spider Drive Bit. DO NOT over
tighten.
1

FURNITURECONCEPTS
®
800 969 4100 [email protected] www.furnitureconcepts.com
FURNITURECONCEPTS
®
066 Camp Ladder End Bunk
Assembly and Parts Good for 30, 36, 39 Sizes
4. Slide the Safety Rails into the grooves carved into
the Top Bed End Panels with the pocket holes facing
inward.
5. Secure the Safety Rails to the Top Bed Ends Panels
with the 8 Square Head Fasteners. DO NOT over tight-
en.
6. Using two people, raise the top bunk section and
place on top of bottom bunk section; making sure that
the metal pins insert fully into the Top Bed End Panels.
7. Place 4 slats perpendicular to Bed Rails and secure
with 1 ¼” Square head screws. These serve as the
support for the foundation and mattress.
2