Furniture of America Egaleo CM5814TV User manual

Left Panel

Drawer Rails
Cap

I. Insert the stud bolt (#B) into a pre-
drilled hole on the glass top (#1).
Turn right to tighten. Insert the shelf
leg (#4) and then the cap (#Q) onto
that stud bolt.
II. Insert 2 stud bolts (#A) into the
remaining 2 pre-drilled holes on the
glass top (#1). Turn right to tighten.
Then insert the pole (#3) onto those
bolts.
I. Insert 2 cam bolts (#F) into the pre-drilled holes along the back side of the
bottom panel (#14). Secure using the Phillips screwdriver.
II. Insert 4 cam bolts (#D) into the 4 outer pre-drilled holes as shown and
secure using the Phillips screwdriver. Then insert 4 wood dowels (#G) into
the remaining 4 inner holes in the bottom panel (#14).
I. Insert the back panel (#8) onto
the cam bolts (#F) and the left/
right side panels (#7/6) onto the
cam bolts (#D) and wood dowels.
II. Insert 2 cam locks (#E) into the
back panel and 4 cam locks (#C)
into the side panels (#7/6). Lock
the cam locks with the cam bolts
using a Phillips screwdriver.
I. Remove the rails inside of the drawer rails (#N).
II. Align the drawer rails (#N) to the pre-drilled holes along the sides of the side panels
(#7/6) and insert 2 screws (#O) into each rail. Secure using a Phillips screwdriver.

I. Insert 2 cam bolts (#F) into the pre-
drilled holes along the back side of
the top panel (#5). Secure using the
Phillips screwdriver.
II. Insert 4 cam bolts (#D) into the outer
corner pre-drilled holes of the top
panel (#5) as shown and secure using
a Phillips screwdriver. Then insert 4
wood dowels (#G) into the remaining
holes of the top panel.
III. Insert 2 cam locks (#E) into the back
panel and 4 cam locks (#C) into the
side panels (#7/6).
IV. Insert the top panel (#5) onto the back
and side panels. Lock the cam locks
with the cam bolts using a Phillips
screwdriver.
I. Apply the the assembled bottom panel
upside down onto the shelf leg and pole.
II. Insert a flat washer (#J) and hex nut (#I)
onto the threaded end of the stud bolts
(#A), Secure using the socket wrench (#R).
III. Insert a flat washer (#j) then hex nut (#I)
onto the threaded ends of the stud bolt (#B)
located on the leg. Secure using the
socket wrench (#R).
IV. Align 2 bottom caps (#15) to the pre-
drilled holes along the sides of the bottom
panel (#14) Insert bolts (#P) and secure
using the Allen wrench (#S).

I. Align the glass shelf brackets (#K) to the pre-drilled
holes along the sides of the pole and side panel.
Insert a screw (#H) into each bracket and secure
using a Phillips screwdriver.
II. Apply the glass shelf (#2) and secure using the
Allen wrench (#S).
Make sure all bolts are firmly secured.
ASSEMBLY IS COMPLETED