Furnotel FSEMM-0304 User manual

Cone baker
Instruction Manual
FSEMM-0304
Shinelong International Co., Ltd
Web: http://www.furnotel.cn
E-mail: [email protected]
Fax:[phone]
TEL: [phone]
Address: 301, Building 1 ,Tian An Hi-tech Ecological
Park Panyu Avenue Panyu, Guangzhou, China

Thank you for choosing our kitchenware series. Please read the manual
book carefully before using the equipment and use only as specified.
Cooking is a culture full of artistry. One of our goals for producing high
quality kitchenware is to help you feel the unique satisfaction and
enjoyment from cooking.
The FSEMM-0304 is our latest generation kitchen equipment .The body
is made from Japanese stainless steel and the smooth appearance is
based on European styling. They are fully–featured, easily to operate,
energy saving and are designed for environmental protection.
一、Component Diagram
二、Parameters
Name
Cone baker
Model
FSEMM-0304
Size(mm)
320*380*266
Power
230V/50HZ
Voltage
2.2kW
Temperature range
50~300℃
三、Operation Instructions
3.1 Safety Instructions

If there is any abnormal appearance while you are using the equipment,
turn off the power immediately. Do not use until safety is assured.
3.2 General operation
A. Turn on the power source and the green power indicator light should
come on. Select the desired power level and proceed to cook.
B. According to your need to choose the suitable temperature. The
temperature range can be adjusted from 50~300℃.
四、 Installation
a. Put the stove on level ground and ensure a clearance of at least
10cm from both right and left side, and at least 20cm from
behind.
b. The working voltage must match the one on the specification
plate.
c. Install the allowable power source; fuse plug and grounding
protection to the equipment. Do not put anything in front of the
power switch.
d. The power connection is under the stove in the rear corner and
connects to ground for safety.
e. The ground wire (yellow and green wire) and power source wire
are in the same wiring harness. Connect the ground wire by
suitable copper bolt if the power point doesn’t have one.
Attention

A. In order to prevent destruction from thunder, turn off power as
soon as possible while the thunder is closing in.
B. Do not destroy the surface or heat plate with solid or sharp
objects.
C. Turn off the power source after cooking is finished.
五、Trouble shooting
Problem
Reason
Solution
1、Power light
(Green)
is not lit
①The power fuse is burned out.
②Thepower wire is
improperlyconnected.
③The light has burned out
1.Replace with a
suitable fuse
2. Tighten the power
wire connection.
3. Replace the light.
2、Power light
(Yellow)
is not lit
①The light is not available
②The circuit is not connected
Change the power light,
Make sure the circuit is
connected
3．The heater is
not available
①The heater is burned out
③Temperature controller is not available
Change heater
Change temperature
controller