Furuno FAX-210 User manual

Your Local Agent/DealerYour Local Agent/Dealer
9-52 Ashihara-cho,9-52 Ashihara-cho,
Nishinomi
y
a 662-8580, JAPANNishinomi
y
a 662-8580, JAPAN
Tele
p
hone :Tele
p
hone : 0798-65-21110798-65-2111
FaxFax 0798-65-42000798-65-4200
::
F
IRST EDITION :
F
IRST EDITION :NOVNOV.. 19911991
Printed in JapanPrinted in Japan
A
ll ri
g
hts reserved.
A
ll ri
g
hts reserved. M1M1 ::AUGAUG.. 06, 200406, 2004
Pub. No.Pub. No. OME-62490OME-62490
*
00080289300
*
*
00080289300
*
*
00080289300
*
*
00080289300
*
(( YOSHYOSH )) FAX-210FAX-210 * 0 0 0 8 0 2 8 9 3 0 0 ** 0 0 0 8 0 2 8 9 3 0 0 *
*
OME
62490
M
10
*
*
OME
62490
M
10
*
*
OME
62490
M
10
*
*
OME
62490
M
10
*
* O M E 6 2 4 9 0 M 1 0 ** O M E 6 2 4 9 0 M 1 0 *

ii
SAFETY INFORMATION
FOR THE OPERATOR
Avoid opening cover of
equipment except to
replace paper, fuse or print-
ing head.
Do not touch printing head
just after printing.
Burn can result.
This equipment uses high
voltage electricity which can
shock.
WARNING
Do not dissasemble or modify the
equipment.
Fire, electrical shock or serious injury can
result.
Use the correct fuse.
Use of the wrong fuse can cause fire or
equipment damage.
Do not operate the unit with wet hands.
Electrical shock can result.
Do not place heater near the equipment.
Heat can melt the power cord, which can
result in fire or electrical shock.
Do not place liquid-filled containers on
the top of the equipment.
Fire or electrical shock can result if a liquid
spills into the equipment.
Immediately turn off the power at the
ship's mains switchboard if water or
foreign object falls into the equipment
or the equipment is emitting smoke or
fire.
Continued use of the equipment can cause
fire, electrical shock or serious injury.
CAUTION
WARNING Label attached
WARNING
To avoid electrical shock, do not
remove cover. No user-serviceable
parts inside.
Name: Warning Label (1)
Type: 86-003-1011-0
Code No. : 100-236-230

iii
SAFETY INFORMATION
FOR THE INSTALLER
Only qualified personnel
should work inside the
equipment.
Ground the equipment to
prevent electrical shock
and mutual interference.
Ungrounded equipment can
give off or receive electro-
magnetic interference or
cause electrical schock.
This equipment uses high
voltage electricity which can
shock, burn, or cause death.
WARNING
Turn off the power at the ship's mains
switchboard before beginning the
installation. Post a warning sign near
the switchboard to ensure that the
power will not be applied while the
equipment is being installed.
Serious injury or death can result if the
power is not turned off, or is applied while
the equipment is being installed.
Confirm that the power supply voltage
is compatible with the voltage rating
of the equipment.
Connection to the wrong power supply
can cause fire or equipment damage.The
voltage rating appears on the label at the
rear of the equipment.
CAUTION

vii
page
CHAPTER 2 MAINTENANCE...........................2-1 to 2-8
GENERAL MAINTENANCE................................................................................2-1
Cleaning............................................................................................................2-1
Thermal Head Cleaning....................................................................................2-1
Lubrication.........................................................................................................2-2
REPLACING THE FUSE .....................................................................................2-2
REPLACING THE BACKUP BATTERY .............................................................2-3
REPLACING THE PRINTER HEAD....................................................................2-5
CHAPTER 3 TROUBLESHOOTING ............................3-1 to 3-4
OPERATOR TROUBLESHOOTING ...................................................................3-1
SELF-TEST..........................................................................................................3-3
CHAPTER 4 INSTALLATION.....................................4-1 to 4-17
RECORDER UNIT INSTALLATION....................................................................4-1
General Mounting Considerations....................................................................4-1
Mounting ...........................................................................................................4-2
ANTENNA INSTALLATION.................................................................................4-4
Variation ofAntenna Installation.......................................................................4-4
Passive Antenna...............................................................................................4-6
Active Antenna..................................................................................................4-6
CABLE CONNECTIONS .....................................................................................4-7
Power Connector..............................................................................................4-8
Antenna Connector...........................................................................................4-8
Break-in Connector...........................................................................................4-9
Ground Terminal .............................................................................................4-10
NAVTEX Connector........................................................................................4-10
PRESETS AFTER INSTALLATION ..................................................................4-12
Voltage Selection ofAC Power Pack .............................................................4-12
Preset for Preamp Unit...................................................................................4-13
Selection of Aspect Ratio for FAX Recording.................................................4-14
LOCATION OF CIRCUIT BOARDS..................................................................4-15
TAPING WHIP ANTENNA.................................................................................4-17

viii
page
APPENDIX A PRINCIPLE OF FACSIMLE AND
NAVTEX SYSTEMS............................A-1 to A-6
HOW A FACSIMLE SYSTEM WORKS ........................................................... A-1
Radio Facsimile System................................................................................A-1
Recording System on the FAX-210 ...............................................................A-3
HOW NAVTEX WORKS .................................................................................. A-4
NAVTEX System Operation...........................................................................A-4
Message Format............................................................................................A-5
APPENDIX B MAPS & LISTS ...................................B-1 to B-9
Facsimile Station Map...................................................................................B-1
Facsimile Station List.....................................................................................B-2
Facsimile Station List (Alphabetic).................................................................B-3
NAVTEX Station Map ....................................................................................B-4
NAVTEX Station List......................................................................................B-5
Private Channel List ......................................................................................B-7
Auxiliary Channel List....................................................................................B-8
Timer Schedule List.......................................................................................B-9
APPENDIX C IMPROVEMENT OF RECEIVER S/N RATIO
(Remedy for RFI) ...............C-1 to C-2
LISTS..................................................................................................... L-1 to L-5
OUTLINE DRAWING.................................................................................... D-1
INTERCONNECTION DIAGRAM..................................................................S-1
Declaration of Conformity

SPECIFICATIONS COMPLETE SET
xii
COMPLETE SET
No NAME TYPE MASS Q’TY REMARKS
1 Main Unit FAX-210 12 1
2 Accessories FP08-00600 1 set
CP08-01100 For ac mains
3 Installation Materials CP08-01110 1 set
For dc mains
Either one is
supplied.
SP08-01100 For ac mains
4 Spare Parts SP08-01110 1 set
For dc mains
Either one is
supplied.
With 15 m cable (option)
5 LF/HF Preamp Unit FAX-5 0.6 (1) With 1 m cable (option)
6 Whip Antenna 04S4176-0 0.5 (1) 2.6 m (option)
7 Extension Cable Kit OP04-2 (1) 10m,20m,30m,40m or 50m (option)
8 NAVTEX Board 08P3119 (1) (option)
9 NAVTEX Preamp Unit NX-5 0.6 (1) With 15 m cable (option)
10 Whip Antenna FAW-6R2 3 1 6 m (option)
11 Whip Antenna FAW-1.2 1 1.2 m (option)
12 Receiving Antenna
Junction Box AJB1-1A 4 1 (option)
13 Clamp OP08-11 1 (option)