Fusion Aquapower User manual

Aquapower
Boat Speed Controllers
FS-AQP128 Aquapower 128A
Thank you for purchasing this Aquapower Speed Controller. We are sure you will be
pleased with its performance and features. In order to ensure that you obtain the
maximum benefit from its operation, please read the instructions carefully.
OpErAting instructions
Please keep for Future Reference
Aquapowe
r
FS-AQP128
Use Boat
Function Fwd/Neutral/Reverse
Brake ABS
On-Resistance (ohm) 0.007
Frequency 3KHz
Max. Peak Current (Amps) 440
Max. Continuous Current (Amps) 128
B.E.C. (Voltage/Amps) 5V/1A
Input Voltage (Cells) 5~10
Motor Turn 18~36
One Touch Setting Automatic
Temperature Cut-Off Yes
Water Cooling System No
Wire Size 1.68
Case Size (mm) 36 x 28 x 18
Weight 49g
•Designed for a wide selection of electric motors between 18~36Turns.
•Automatic Set-Up
•All connectors factory fitted
•Temperature Cut-Off shuts down the speed controller to prevent damage
from excessive current draw.
SpECIFICATIOnS
FEAturEs

1) Set the throttle reversing switch to reverse on Futaba transmitters and to normal
on most other transmitters.
2) Connect the Aquapower speed controller to the throttle channel on the receiver,
ensure that the speed controller is switched “OFF” and then turn “ON” the
transmitter.
3) Connect the drive battery.
4) When the speed controller is switched “ON”, the position of the throttle
stick/trigger will be the neutral position. The Green LED will light up.
5) Move the throttle stick/trigger to the full forward position to set the full throttle
position. The red LED will light up.
6) Move the throttle stick/trigger to the full backward position to set the full reverse
position. The red LED will light up.
7) Move the throttle stick/trigger to the neutral position again and the green LED
will light up to indicate that the speed controller is now set up and ready to
operate.
If the last green LED does not light up, then repeat the Set-Up procedure again.
If the motor operates in reverse when it should be going forwards, then reverse the
throttle switch on the transmitter.
www.logicrc.com
Logic RC Limited
14 Hartham Lane
Hertford
SG14 1QN
United Kingdom
sEtUp